Jump to content
SAU Community

Recommended Posts

I am look at buying a stagea and want to ask a few questions.

What model do i need to get a manual??

How much would a 260RS cost or would it be cheaper to put a RB26 in later??

Can the 2.5 be modified with a RB30 bottom end??

Can they be changed to RWD like the r32 GTR??

Any help would be great.

Thanks

Rob

Edited by WHITER33GTS-T
Link to comment
https://www.sau.com.au/forums/topic/87778-looking-to-buy-a-stagea/
Share on other sites

Hey Rob,

Manual, you would need either a series 2 NEO Manual

or

a 260rs

In regards to the RB26 Conversion, I would be inclined to say that its cheaper to buy and convert. But still I'm not too sure. Better to talk to Stagzilla on that one... :)

RWD. Now as far as I know you can but cant. So basically, you can convert it to RWD with the attesa controller, but you cannot get it fully RWD. Thats all I know on that one... B)

I hope that helped a bit.

Cheers,

Chris :D

I used J Spec, very helpful and great service. Have a chat to Ben Lippa :D

www.j-spec.com.au

[email protected] (Email)

Front end conversion, I have been quoted (By garage-13) $5750 for the front end kit + $1500 for the install <_< I think you could get it cheaper....just have to shop round.

I'm planning on getting the 260rs bodykit when I get some more money. B)

Cheers,

Chris

Edited by Stagea RS-Four
Thanks Chris,

Also is it very expensive to do a R34 conversion front end?

I am after something a bit different as i am in Tassie and there are R33's every where.

You won't need an R34 front end to be different, Stagea's are rare as hens teeth as they go. Find a nice one, put some nice wheels and a bodykit on it and you'll be set

260rs is cheaper, though the km's are probably gonna be around 100 000km (even if dash says 40 000km or some rubbish) and the rb26's r prone to cracking piston ring lands and blowing excess oil out past the rings, so make sure its genuine low km's.

i would have gone 260rs but i already had the rb26 engine and i thought it would be cheaper (and easy :D )

good luck

Brad

hey i just warn u the stagea is a heavy sucker :D

weighed mine with no driver and half tank of fuel and sub box and 2 amps in it, and it got 1800kg exactly.

even with 350rwhp it was abit of a slug off the line, the rb25 auto on the other hand was a beast to launch off lights fast :) just lacked up top, and the 26's top end makes up for it, and the manual goodness :D

rb30 bottom end is possible, need a sump adaptor because the rb30 block doesnt have the 4wd bolt pattern.

the stock axles on the diff r tiny and so are the uni joints so 3L torque would munch them in no time, my 26 snapped one clean in half just coming onto boost while rolling along in 1st gear.

the stageas can be put in 2wd, plenty of different methods, remove front tailshaft or undo the line off the rear of gearbox and screw it into a spare actuator (same as thing thats on rear of gearbox) to stop it pressing the clutch packs together :)

hope it helps

Brad

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The rain is the best time to push to the edge of the grip limit. Water lubrication reduces the consumption of rubber without reducing the fun. I take pleasure in driving around the outside of numpties in Audis, WRXs, BRZs, etc, because they get all worried in the wet. They warm up faster than the engine oil does.
    • When they're dead cold, and in the wet, they're not very fun. RE003 are alright, they do harden very quickly and turn into literally $50 Pace tyres.
    • Yeah, I thought that Reedy's video was quite good because he compared old and new (as in, well used and quite new) AD09s, with what is generally considered to be the fast Yokohama in this category (ie, sporty road/track tyres) and a tyre that people might be able to use to extend the comparo out into the space of more expensive European tyres, being the Cup 2. No-one would ever agree that the Cup 2 is a poor tyre - many would suggest that it is close to the very top of the category. And, for them all to come out so close to each other, and for the cheaper tyre in the test to do so well against the others, in some cases being even faster, shows that (good, non-linglong) tyres are reaching a plateau in terms of how good they can get, and they're all sitting on that same plateau. Anyway, on the AD08R, AD09, RS4 that I've had on the car in recent years, I've never had a problem in the cold and wet. SA gets down to 0-10°C in winter. Not so often, but it was only 4°C when I got in the car this morning. Once the tyres are warm (ie, after about 2km), you can start to lay into them. I've never aquaplaned or suffered serious off-corner understeer or anything like that in the wet, that I would not have expected to happen with a more normal tyre. I had some RE003s, and they were shit in the dry, shit in the wet, shit everywhere. I would rate the RS4 and AD0x as being more trustworthy in the wet, once the rubber is warm. Bridgestone should be ashamed of the RE003.
    • This is why I gave the disclaimer about how I drive in the wet which I feel is pretty important. I have heard people think RS4's are horrible in the rain, but I have this feeling they must be driving (or attempting to drive) anywhere close to the grip limit. I legitimately drive at the speed limit/below speed the limit 100% of the time in the rain. More than happy to just commute along at 50kmh behind a train of cars in 5th gear etc. I do agree with you with regards to the temp and the 'quality' of the tyre Dose. Most UHP tyres aren't even up to temperature on the road anyway, even when going mad initial D canyon carving. It would be interesting to see a not-up-to-temp UHP tyre compared against a mere... normal...HP tyre at these temperatures. I don't think you're (or me in this case) is actually picking up grip with an RS4/AD09 on the road relative to something like a RE003 because the RS4/AD09 is not up to temp and the RE003 is closer to it's optimal operating window.
    • Either the bearing has been installed backwards OR the gearbox input shaft bearing is loosey goosey.   When in doubt, just put in a Samsonas in.
×
×
  • Create New...