Jump to content
SAU Community

Recommended Posts

That dosent tell you anything, all it says it you cant fit a bigger motor without telling them, you can get approval to fit a bigger motor though.

The problem is that you would need an inspection and we are not going to fit a bigger motor and leave it stock so ti wouldnt pass.

Link to comment
https://www.sau.com.au/forums/topic/8899-well-this-sux/#findComment-131236
Share on other sites

I think you need a PCV valve in the inlet manifold, so all you can do is take the rocker breathers to a catch tank then filter the air somehow and run a hose to the manifold.

This means that the rocker cover may be under pressure as there is no where for the gas to go other then the manifold, in which it would then need more pressure to vent back in, if you know what i mean. Ive seen a few setup the same so it must be ok.

Link to comment
https://www.sau.com.au/forums/topic/8899-well-this-sux/#findComment-131328
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So sadly the fuel pump etc was not it. The pump and filter is new and it is still cutting around 4000 rpm. A read something about ABS/TCS (engine is from stagea and ECU too so no TCS) and i dont know for 100% that my car has ABS. It has ABS "cube" in engine bay but i dont think it works(or at least from my braking experience). Can be something like that?  I will be driving the car next week to Nistune tuner to properly see what is wrong...  
    • the Tomei LSD fluid with lsd kit. frustrated that it was shaking the car to crap and affecting everything else negatively, I pulled the diff last night, and removed the lsd carrier, could not find anything wrong, however it seem to be 100 locked up acceleration, and deacceleration, wondering if they sent me a 2 way not a 1.5??  either way I installed the stock open carrier back in place. test drove everything smooth as butter again. no shake, shutter, random, what felt like clutch slip and grab or drive shaft play, etc. something differently wrong in side the lsd. I might bother taking it apart (if possible) to figure out what's going on inside this carrier, as bought too long ago to return.  only draw back is its back to a one wheel wonder.
    • If there's oil in with the clutch, I hope it finds its way out even if that hole has a cover/grommet 😛 I don't want oil near my cars clutch! 😛 Interested to hear the answer about covering it, I'm assuming a bung for a gearbox from another car that has a grommet to suit.
×
×
  • Create New...