sn00p

will take pics of the f/cut for you this week?

Yep ok will disconnect it tommorow. PM me your details and I will COD to you.

benm - Sorry will be using it.

vendetta - No, didnt come with s/wheel

lindsey34- The steering wheel shroud yes. Nothing below that. Sorry not sure if it S1 or S2 how do I tell?

Yep I have it. Pm me with offer.

rbhead - Is control arm castor rod? If yes sorry its spoken for but if deal falls through u can have it. ma160802 - Yes. PM me with offer.

Swaybar Engine mounts Cross member LHS & RHS Complete Suspension setup Glovebox Centre console surrounding aircon and headunit - average condition Whole dash - few scratches and dirty but no cracks Pedals SR20 - Crossmember sn00p180sx@yahoo.com.au Many other parts that I may not have listed, please PM me or email me for more details. Make offers on any items. Located in Newcastle, will COD but might cost a bit as some items are quite big.

It would be

Haha the chicks are the only good things about buses. The smelly fat sweaty bums are a major downer. I went through this aswell when i lost my lic for 4 months

any reasonns?

what do people think of these boost controllers?

u sure it exists?

yep pics would be easier to understand

hikariperformance.com sells s/steel piping kits.

try silviansw.com

I think the rb30det will be too high to fit in my engine bay. Its tight squeeze with rb25, i think rb30 block is about 1" higher

Mase - Yes I'm doing the conversion myself. I will get help with the wiring from a mate who has done rb20 conversion, so that shouldnt be hard. 2.5k all up sounds fair for rb20 costs, but im putting a rb25 in, there is no use getting rb20 over sr20. Ben

"As a general rule, I can't see the point of the 300 high cooler as half of it is hidden behing the bumper doing nothing." Thats the same on my car but the bigger the surface area of the cooler the longer it will take to get heat soaked when idling in traffic etc.

Passage31 - PM sent

Im only after engine and gearbox CROSSMEMBERS. Do you have these?

Sydneykid - How did you do this? By using non-HICAS p/steering resovoir, or just put less oil in it.

Needed asap. please email me at sn00p180sx@yahoo.com.au Thanks Ben

1 r33 cross over pipe for fmic pic plz sn00p180sx@yahoo.com.au

Been too all the import wreckers most of them are charging too much. Im after engine, gearbox, ecu, wiring harness, cross members (engine and box), and everything else needed for conversion. Please PM me or email me with prices. Thanks Ben Pref in Sydney. sn00p180sx@hotmail.com