Jump to content
SAU Community

Recommended Posts

Hi all

Looking at getting an Apexi SAFC to improve fueling and hence fuel economy?

My GTT is rather stock except for a turbo back, and would like to get some extra kms or power out of the thing.

No plans for high boost, 10psi would be my maximum. No plans for huge mods (not even a FMIC) so no real point getting an expensive PFC.

With a stock setup, and if I keep the boost the same, will I see any gain in either power or fuel economy?

Or does this thing only really apply for a higher boost setup? ie. at 10psi will it be worthwhile?

If anyone has ever used a SAFC on their car, let me know your experience and what you guys think of it.

Thanks

Link to comment
https://www.sau.com.au/forums/topic/106045-effectiveness-of-a-safc/
Share on other sites

you wont get much better fuel economy.

while off boost and in closed loop mode, your A:F ratio's are probably close as possible to 14:1.

when you get on the gas, then it gets richer and richer.

so in standard form it might get to about 10:1.

an SAFC or any air flow meter signal bender for that matter, will only make an adjustment at full throttle type position.

so you can adjust that 10:1 to about 12:1.

pick up a hand full of KW's while your at it and the the car will use less fuel (JUST) when it is on full throttle.

I doubt you will actually save any money though, considering the car will have more power and be more fun to drive, you will be up it more often.

I had an SAFC on my S14.

it gained about 11rwkw on the same boost just by getting the mixtures to 12:1.

fuel consumption was still the same.

if you are not going to mod the car i wouldnt worry about it. upping the boost a bit might cause it to run a little richer though. I guess easiest thing is do the mods that you want chuck it on the dyno and see what the afr's are like. If they are really rich then buy one if not dont worry.

well I pulled 230rwkw out of my R33 witha safc2 and now I am after new kw target.

A very good unit and easy to wire into the car. well my cars fuel usage was the same as before but got a heap more power out of her.

selling my SAFC2 very soon so if interested drop me a PM mate!

you wont get much better fuel economy.

while off boost and in closed loop mode, your A:F ratio's are probably close as possible to 14:1.

when you get on the gas, then it gets richer and richer.

so in standard form it might get to about 10:1.

an SAFC or any air flow meter signal bender for that matter, will only make an adjustment at full throttle type position.

so you can adjust that 10:1 to about 12:1.

pick up a hand full of KW's while your at it and the the car will use less fuel (JUST) when it is on full throttle.

I doubt you will actually save any money though, considering the car will have more power and be more fun to drive, you will be up it more often.

I had an SAFC on my S14.

it gained about 11rwkw on the same boost just by getting the mixtures to 12:1.

fuel consumption was still the same.

Actually the SAFC has a high and low throttle map so the low throttle map can be tuned for max economy while the high throttle map can be tuned for power

I love my SAFC in my automatic 4wd Stagea.... plus have it tuned with a duel-stage EBC (10/12psi) and a SITC.

Had the SAFC tuned as a standalone unit at 10psi and had 140awkw with cat-back exhaust and stock R34 GTT intercooler (and with a new O2 sensor made an extra 150kms per tank)..... added the SITC, dump pipe and fmic and now have 160awk at 12psi still getting 400kms per tank before reserve (was 250kms originally).

If youve got an auto Id highly recommend it. But Id also recommend grabbing a SITC as well for the ignition timing alterations, as well as the air/fuel that the SAFC helps you tune.......

With my combo Id expect over 200awkw with a highflow turbo at mild boost.

I love my SAFC in my automatic 4wd Stagea.... plus have it tuned with a duel-stage EBC (10/12psi) and a SITC.

That's all well and good but not many stores sell the SITC?

EBAY!!! You can find everything on ebay. Search via worldwide (Super ITC, SITC, etc) - they come up fairly regularly, but I was lucky enough to find a BRAND NEW IN BOX unit!!

And only paid $220US for it as well including shipping from USA to Adelaide, whereas 2ndhand units sell for near the same price.

Now trying to save for a hiflow with GT30 internals..... but havent found one on ebay as yet, lol

  • 1 month later...

Hey Guys,

Definately a lot to read about and learn.

Obviously different things work for R32, 33 34 etc.

I have an R34 GTT 4 door. Has anyone had much experience in what works here?

What gadgets are best fit for better performance and consumption from airflow to boost controllers etc.. or all in one units?

Cheers,

Paul.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Gday Thought it was about time I started a build thread! As expected this project has snowballed into a huge financial liability, but unless you’re strong willed and responsible, it’s not a surprise. Background -  My first turbo car was an R32 GTS-4, got my full license and then totalled my Au Falcon a week later, so while trying to sell my RMZ450 dirtbike to buy another car a bloke offered to swap the R32 which at the time I felt like I was ripped off but looking back and seeing prices of those now ($40kish) it was a good deal, I didn’t know enough about these cars to appreciate what I had so sold it before the RB20 blew up. Between here and there, out of 12 cars I’ve owned the note worthy ones are a V8 Lexus SC400 (soarer), a couple of XR6 Turbos and my beloved S15 which I had for about 3 years, picked it up for $12500, repairable write off but she was fine, gun metal grey/pewter and bone stock/unmolested until I got my hands on it. Ended up spending about the value of the car and 280kw, 2 demerit points by the time I got defected and sold it for $14500 (also $40kish in today’s market, rip) Fast forward to the present day, I’m in a much better position financially and daily an MQ Triton (great cars, pipe down Ranger Bois), I cruised marketplace and car sales for a few months looking for another R32, the best deal I could find was an absolute rust bucket half finished project for $12000, until this R33 popped up in Port Macquarie for $18k - unregistered and barely running but decent shape, kept an eye on it for a few weeks and the price steadily dropped, $16k then $15k then $14k, that was the point where I was like shit someone’s gonna snatch this up! It was owned by a young bloke who had big plans but him and his missus just had a baby so smartest move financially for them but big gain for me. So 2 days later I’m towing a car trailer to pick this thing up. Roughly 2 weeks and $3500 later I’m cruising around Newcastle in my beat up R33 all smiles and dose noises! It only needed some basic shit to get it going, coil packs and air flow meter, electrical stuff and all fluids changed, 158k kms and running pretty good, nice smooth engine after oil and coolant flush - when I say coolant I mean it had been filled up with tap water, every gallery and heater element was filled with rust, 8-9 flushes later and still had brown liquid coming out but she’ll be right. The car was painted R34 Bayside Blue at some point but whether it was a cheap job or just not looked after is anyone’s guess, clear coat flaking like sausage roll.  Was rethinking my choices and contemplating life, had it up for sale for $22k - still cheaper than any registered R33 but got little interest, next minute I had an opportunity at work - 6 months overseas for good money, so that was a no brainer, fast forward again and here we are with a 50% finished project. Current Mods - 200ish KW according to butt dyno Was tuned with Apexi PowerFC EBC (old school Greddy Profec)  Stock turbo (more shaft play than a Tinder date gone right) 3inch turbo back Varex muffler  Aftermarket injectors of mystery size, Power FC showed 36% duty cycle at full boost so not behd good size Someone had good intentions but stuck with the stock R33 MAF so we had misfires at 6000rpm due to the MAF hitting 5.2V So far I’ve redone the entire interior with carpet form Car Mats Direct, new Seats and steering wheel from Autotechnica, also sound system by Autobarn (mainly Kicker) Also MCA pro comfort coil overs - Hands down best purchase yet, worlds of improvement over the tired 30yrold shocks Goals - 450kw/600hp on flex tune New paint job - Midnight Purple 2 Engine is at the shop getting rebuilt with forged rods a pistons, new valves and springs, ATI Harmonic balancer, Aeroflow 7.5L sump, rear head drain and oil restrictors as per oil control thread* and cam covers modded for larger breathers, other stuff I can’t recall of the top of my head Parts purchased and to be installed once the engine is done -  Engine loom from Wiring Specialties including these options: Haltech Nexus S3 R35 Coil pack conversion  PRP Dual Trigger kit Fan controller  Other Parts -  262 Kelford Cams Turbo - Hypergear ATR43SS3-ProS with T51R mod (whistly boi) 6 boost manifold (high mount) 50mm Turbosmart Pro gate (plumbed back for legal reasons) HKS Super Turbo Exhaust with High Flow Cat Custom 3.5inch dump and front pipe 1500cc Bosch injectors  Fuel Pump walbro 525 Haltech MAP and IAT sensors Haltech Flex Sensor Fenix Radiator with dual thermo fans LS1 Alternator Kit Oil Filter Relocation from EFI solutions and Cooling pro oil cooler Many other things sitting in my garage waiting for that engine to come back. Progress pics to follow -  
    • Losses have to be less with DC coupling. Provided the battery inverter has decent MPP tracking ability - which really shouldn't be a problem. It's not 2005 any more.
    • Hi, Will the R33 GTR rear brake backing plates fit a GTST? I'm struggling to find GTST ones but can find new GTR ones.   Thanks.
    • I also got the same floor mats for a bit of extra bazzaz haha
    • Some more close up pics now that I’m back to working on the car, the loop pile is nice but again haven’t compared it to the other types in person, it’s hard to tell from the pics on the website. View of the hemming on the edges too, it comes in 2 pieces - front and back, honestly very happy with it for anyone on the fence.  Also attached my previous pics from further up as it didn’t let me post them directly before. (Nothing worse than photo bucket pics that aren’t hosted anymore years later)
×
×
  • Create New...