Jump to content
SAU Community

Recommended Posts

I was wondering if anyone knows or can recommend from experience any good places in melbourne (preferably northern suburbs) who will re map my ecu to accomodate for my mods? (10 psi, fmic, turboback exhaust).

Also what are the prices like to remap (r33 gtst)

thanks heaps

Link to comment
https://www.sau.com.au/forums/topic/106774-remapping-rb25-ecu/
Share on other sites

how bout reset ur ecu, let it remap itself?

its free!

i think it work the same thing!

That might reset the idle and closed loop control but as for remapping an R33 it is very difficult as the memory segment in which the calibration data is sotred is internal to the microprocessor. The device is write once only, which means every change you make you throw away that processor and start again. Not to mention you have desolder the acutal chip itself which is quite involved and has its risks.

The actual tuning is really quite easy and there is no checksum routines to perform or bypass thank god(you should see the 996TT checksum routine). As for places in melbourne I have no idea but I think there is a guy on this forum that has done a few using the techtom boards, weather the tune wa any good is another story.

You mean chip it?

I thought you couldn't reprogram the R33/34 ECU's, only the 32's?

I think you'd need to look at a piggyback/chip setup.

It can be done. Search for the old sticky 'What is the GReddy Emanage thread' or something like that and u will find in the last couple of pages a discussion about this. From memory the guy from Melbourne that does it has his details there!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Dredgggggeeee time; I have recently finally started driving the car. It sat for so long that the fuel tank gave birth to rust sludge and blocked my lift pump sock and one of my walbro 460's and left grime, rust chunks and muck all through the surge tank and system. I decided to commit and pull the trigger on an oem r32 gtr fuel tank and Frenchys twin 460 / sender / surge tank hanger combo and all new larger lines and fittings etc, also boost doc heater hose kit / new heater core and a heap of other bits and shits like wideband sensor installed in the dump and Syltech iacv + lines and all wired and added to current tune. now having lightly driven it a couple times without issue, I can happily report on the hta3076 in its current tune. still no boost control switched on, 20psi gate springs, car makes 22psi at 3200rpm in 6th gear with 30-50% TPS from cruise at 100kmh. Going by the old graph, this means it should be making 300-325whp at the same numbers above. Very very responsive setup under true road driving loads. all that's left for the build is body loom + PDM, finish the remote aircon setup, install carbon fibre parts and go for full tune and 30psi. the 315 rear tyres are now performing like they're 195's, wheel spin in any gear at almost any rpm, whereas my previous setup hooked up in 3rd no issue, albeit Nt01's back then / RB25 5spd vs (new) old date r888r's Z34 6spd now, + obviously all the support upgrades I listed in the quoted post above. car sits at 1-3psi on cruise at 100kmh, expectations totally exceeded and I'm beyond stoked with all this so far. IMG_4848.mov
    • I've also been eyeing their rear axles for my car. I purchased seat mounts from them about 7 years ago and they were hot garbage so I've been a little wary about purchasing them. With that being said, please buy them and get back to us haha. 
    • Can a moderator please move this into the right category.. I've accidently put this into racing build thread 🤦🏽‍♂️
    • Being a manual, we very quickly ordered new R34 gearbox (From Nissan) and remaining parts from Kudos motorsports. Would highly recommend the team there. Ultra helpful and quick to share advice and upgrades. We are in the middle of taking the Auto out (Genuine 94,000/kms) and putting the Manual in this weekend. Part 2 of the build will include likely a Plazaman Intercooler and Plenium, Hks Exhaust with Tomei Dump (ordered).
×
×
  • Create New...