R31 Pintara Gxe

[Boostkid]

OK So I believe my power cable for my amp is 8 gauge perhaps....

I need a grommet in the firewall for it to pass through. The only one I found so far is the one for my bonnet release which has the steel cable passing through it or the one that's just near my air con (but there's no interior access cos of air con shit taking up all the room inside). Any more places that I haven't seen yet??

I got my rca's and rear speaker wires to run up the side of the car under my carpet (it's a pro job, did it myself and you can't see cables anywhere !)

Just need the power to run down the left side of the car now.

Battery is on the right tho. So it'll be crossing the car (under the dash, inside) if I can find a suitable grommet on the right side.

Thanks guys

[Boostkid]

BUMP

[(OO_The4door_OO)]

OK, most cars will have ample space in the passangers footwell.

Pull the carpet and heat cloth out of the way, and look for a suitable grommet. You may have to search right up behind the dash aswell.

It doesn't matter if the grommet is on the oppisite side to the battery, you should run the cable through PVC loom like : http://www.jaycar.com.au/productView.asp?I...eMax=&SUBCATID=

and if there is no grommet for your cable the next best pro-move is to drill a hole with one of these : http://www.jaycar.com.au/productView.asp?I...eMax=&SUBCATID=

and then fit in a grommet like this one to seal the fitment, put the nut end on the outside if you can : http://www.jaycar.com.au/productView.asp?I...eMax=&SUBCATID=

And don't forget to run the power lead and RCA leads on opposite ends of the car!!!

Let us know how it goes.

[Boostkid]

I ended up just going through the same grommet that carries the bonnet release cable.

Had to stab a little out to make it a slightly more comfy fit

ran it behind the accelerator then forwards under the dash to the other side of the car and to the back (PVC PIPING COMES IN HANDY WHEN GETTING FROM CABIN TO BOOT).

it all runs OK.