Jump to content
SAU Community

Recommended Posts

well i jsut purchaced a R33 GTST a while back.

and they never said anyhting about the computer infact they know quite little about the car.

i took the kick pannel off today and on the ecu theres a gold plate saying it has a Mines ecu.

does anyone know if these are good? and what they are worth?

will have some pics soon, just gotta find this usb cable.

Link to comment
https://www.sau.com.au/forums/topic/11301-i-discovered-somthing/
Share on other sites

o and a tip to all you people. search your boot side 1/4 pannels u will be suppriesd what u find,

(open boot pull carpet stuff off stick hand down side and watch for snakes)

mine has some wierd looking cotton gloves, stanless steal brackets with price tags, some japanese money and bits of newspapers.

*note* i will not be held responsable if u get bitten by snakes.

just a q, since im not 100% sure where to look for the ecu.... where should i b looking and what should i pull off to get to it etc????

only cos the last owner ofmy car sed that he wasnt sure if it had a a/m jap chip in it

Hehe, MotoX funny you mention the rear quaters .... I searched mine about 5 days about as the person who was workin gon the car put the shifter pouch back in there with the jack and the shifter fell out ....

Found Japanese chewing gum (still in the packet), another shifter, misc japanese paper, and a few other goodies .... no snakes .... will have to check the other side :P Also interesting to check inside or the fron quater panels, and inside the doors ....

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I've been doing some looking around and honestly was just considering throwing a new rack at it. I saw that the dmax silvia rack bolts up into the 33 with the silvia bushings but not sure if the high pressure lines will sit in the correct spot. I believe other version of the 33 rack are the same/similar to the racks that can be opened up without as much fuss so I assume the dmax rack would fit but any ideas?
    • I've never played with one, but I would expect that you are correct. That slot looks like it is intended to be used to unscrew the end, and the flats on the body would be better than grabbing it around the round bit with a pipe wrench. So, yeah, probably unscrews. You'll probably have to make a tool to drive in that slot.
    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
×
×
  • Create New...