Jump to content
SAU Community

Cruise This Weekend - 24/6/2006

KNGRACING

By KNGRACING,
in Archived Events

 Share

Recommended Posts

KNGRACING Newbie

KNGRACING

Posted
Posted (edited)

cruise1.jpg

6:00pm - EAST & SOUTH EAST MEET POINT(MINI MEET) -

World Vision Carpark - Vision Drive, East Burwood, MEL REF: 62 D8

(Leaving @ 6:30pm to Main Point.)

6:00pm - WEST MEET POINT(MINI MEET) -

Watergardens Bunnings Carpark(Near the KFC), Cnr of Melton Hwy & Kings rd, Taylors Lakes, Melways Ref: P10 C4 (Leaving @ 6:30pm to Main Point.)

7:15pm - MAIN MEET POINT WHERE WE ALL MEET FROM EACH MINI MEET: Under the Westgate Bridge Carpark, Lorimer st, Port Melbourne, Melways Ref: P42 D12

From the Main Point we will all be going for a cruise which will be all said in the maps we provide you.

KNG Racing does not support or condone burnouts, drag racing or any other Illegal activities, any person's/vehicle's caught doing any illegal activities will have their registration taken. KNGRacing is not responsible for any damages/injuries sustained while participating in such events.

Please invite your friends and spread the word.

Hope to see you all there :D

Edited by KNGRACING
Link to comment
https://www.sau.com.au/forums/topic/122925-cruise-this-weekend-2462006/
Share on other sites
Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • The Bogan
      NC MX5

      By The Bogan · Posted

      The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Komdotkom
      R32 Gtst - Track Car

      By Komdotkom · Posted

      Good luck on the weekend mate
    • Duncan
      From Japan and back to Europe, my sh*tbox R34 GTT

      By Duncan · Posted

      Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Duncan
      New

      By Duncan · Posted

      Welcome to SAU, what are you looking at buying?
    • GabsReDeal
      R32 GTS (RB20DE) Injectors Replacement

      By GabsReDeal · Posted

      I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...