Jump to content
SAU Community

Recommended Posts

hey all

Searched around and could not find any solutions to my query

so here goes................

I ripped apart rocket cover and was lookin at the coil packs

trying to pull em out to change spark plugs and they dont budge, i didnt use too much force as a lil worried i might snap something.

Anyone have the same issue or know why this is happening

Every bolt,screw,nut,tom,dick and harry is undone

Engine: RB20DET

thanks guys

Link to comment
https://www.sau.com.au/forums/topic/127494-sparkies-dont-wanna-move/
Share on other sites

They have like little rubber socks that goes onto the tops of your plugs, and youll have to pull em up reasonably hard to get em off. So yeh if i was you id re-screw in the 4 bolts on each pack that bolts them to the metal brackets, and then just yank the brackets up. Leverage is probably needed

They have like little rubber socks that goes onto the tops of your plugs, and youll have to pull em up reasonably hard to get em off. So yeh if i was you id re-screw in the 4 bolts on each pack that bolts them to the metal brackets, and then just yank the brackets up. Leverage is probably needed

You have 4 x small screws at each c pak and larger bolts on each bank of coil paks attached to the head- yes/ Make sure you undo every one and remove, if they are tight try a small screw driver under the larger plates- 3 i think from memory and pry upwards , cant hurt any thing - the coil pals will come with them . - good luck.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • That looks good, but I think you're going to need much beefier side skirts now.
    • They are daft and there's a reason it never caught on. Steering feel? We don't need no stinking steering feel!
    • I gotta pull you up on this. It's driving me crazy. A shutter is something that closes, like over a window or in a cmera. The word you want is shudder. That LSD is clearly f**ked. Take it to a diff shop and get it disassembled and examined by an expert. YOu might have plates welded together or something equally crazy.
    • Define "starting to fail". Wy not just rebuild them?
    • Check the Nistune doco. There are a few assumptions being made here that might not be valid. I will list the things that occur to me: Base map. Base map for what? Base map for Z32? Then the cranking pulse width is probably wrong for an RB25. The extra 500cc of capacity might well be enough to prevent it from catching. Base map for RB25? I don't think you can load one of those into a Z32. You have to just make the settings correct for an RB25 in the Z32 base map. That is either K or the TIM to get the pulsewidth right. Loom. You bought a loom for an RB. And you plugged it into a Z32 ECU. Did you make sure that any iwre differences were swapped. From memory, there's at least a couple. And as per the others, I would suggest making sure that the fuel pressure is correct while cranking and that the injectors are actually flowing as expected. They really must come out and go on the bench, unless you do find that you have messed up as per above points. I would also suggest watching in Nistune to make sure that everything is reading correctly. That the correct binary flags are raised at the right time (like the crank signal), that there's no stupid values in K or TIM. That you have not got mismatched firmware for the ECU and/or a wrong image loaded.
×
×
  • Create New...