Jump to content
SAU Community

Recommended Posts

  • Replies 164
  • Created
  • Last Reply

Top Posters In This Topic

I have Taken It Apon Myself To Invite The R31 Skyline Club As To Allow For The R31 Skylines Australia Owners ;)

Well There Has Been A Post Put In So Hopefully There Should Be A Good Turn Out Of Nissan (Power)

Good Chance To Get To Know All the Fellow Skylines Australia Club Members And The R31 Skyline Club Members.

To All That Attend Enjoy The Nite.

Regards,

Ashley Neal

Ok Northsiders, the plan as it stands at the moment is to meet at deagon 7-11 and to leave there by 6 at the latest. PM me if you don't know where it is. Let me know if your going to meet there so we don't leave without anyone. From there we head down the gateway to springwood and meet up with the others, then head down the coast.

Any Q's, PM me

Knoxy

Guest Batshane

That sounds good, let me know if you need some help with locations, as I know every nook and cranny of the Coast. The Blackall range is a great drive and the Coast road from Mooloolaba to Noosa is a dream. Mooloolaba and Maroochydore are the places to hang, however its a little boring since they tightened the thumb screws up here. A shit load of skylines would be a pretty picture.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Update: tested my spark plugs that are supposed to be 5ohms with a 10% deviation and one gave me a 0 ohms reading and the rest were 3.9ohm<, so one bad and the others on their way out.
    • 9" wheels are a little too wide for a RWD 32. They can fit. People have put R33 GTR wheels on 32s for years and years. But they are a very tight squeeze. This has been known for about 30 years. As I said - there is no difference between a 17 and an 18 in terms of what will fit. The rolling diameter needs to stay about the same as stock - not very much larger. If you increase that, you will start to have problems. If you increae rolling diamater at the same time as yo increase width, you will have problems earlier. as 9" wheels are pushing the boundaries already, you would need to be careful with tyre choice. I would put 8.5s on the front of mine, but would expect problems with 9s.
    • post up screen shots of your injector tables
    • Diagnostic flow for a code 21 says check signal at the ECU pins, on a voltmeter of some kind it should read 0.1V at idle, 0.12V cranking, 0.15-0.25V at 2000 rpm. Check each coil such that +1, -3 is infinite or very high resistance, -3, +2 should do the same. (-1, +3), (+3, -2), (+1, -2), and (-1, +2) should all be somewhere between 0 ohms and high resistance. If you trace the path from the coil pin all the way back to the ECU in the diagram the resistance you measure at the coil vs connected to the harness should be pretty much the same. 
    • I have an elite 2500 running an adapter harness on an rb25de neo r34. I took the butterfly out and removed all that junk. But I also went Plus+t at the same time. The butterfly thing works in reverse to the boost solenoid on the Gtt if that makes sense
×
×
  • Create New...