Jump to content
SAU Community

Recommended Posts

I was considering putting my RB25DE on the bottle for the 1/4 m, jus wondering if anyone has done this b4, i wanted to kno what else goes along with it ie do i need a/m fuel pumps or a/m ecu that will advance timing? also costs involved and maybe if anyone knows who would install it?

cheers

Link to comment
https://www.sau.com.au/forums/topic/131710-nos-for-na/
Share on other sites

dcanna PM replyed.

Hey guys, i used to run a zex wet kit on my 25, with a 75hp shot of giggle gas. Engine handled without a problem. Went from a 15.8 down to a flat 14. Just make sure ur clutch is up to the task and go for gold. I ran the gas on the car for probably 18 months. the last couple of months before doing the engine conversion i intentially tried killing the engine at every chance i got but couldnt. They are very tuff little succers. and it still ran as good as the day i bought the car 5 years ago. Just dont forget to retard the timing a couple of degrees when its on the bottle and you'll be fine.

Link to comment
https://www.sau.com.au/forums/topic/131710-nos-for-na/#findComment-2444543
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Despite the level up question, actually I do know what that is....it is a pressure sender wire.  So check out around the oil filter for an oil pressure sender, or maybe fuel pressure near the filter or on the engine. Possibly but less likely coolant pressure sensor because they tend to be combined temp/pressure senders if you have one. Could also be brake pressure (in a brake line somewhere pre ABS) but maybe I'm the only one that has that on a skyline.
    • Pull codes via the self-diagnosis procedure. As far as I can tell this is just a sign of transmission issues but not a code unto itself.
    • Hi All, putting the engine back together and everything is perfect except have this plug left over.. any ideas what it is for and where it goes? Is on cold side under the intake plenum *note not a stock plug, as everything has been modified Cheers
    • Sounds like a misfire. Check fuel pressure and don't even think about going into boost while it's like this unless you enjoy engine rebuilds.
    • Just. Gasping. Here. Just. Gasping.
×
×
  • Create New...