Jump to content
SAU Community

Recommended Posts

yeah hi my car has no rego so i cant go driving it on the road to anywhere...

is there some sort of test i could do in my back yard to tell if my rings are worn

like hold the revs at 6000rpm for so many seconds and see if it blows smoke or something..

if u know someway i can go and test my car now please tell me and write back to this asap

cause i want it all running good again.

thanks people

Link to comment
https://www.sau.com.au/forums/topic/144431-how-can-i-tell-if-my-rings-are-worn/
Share on other sites

Compression and leak down test

can u give me all the names of the parts i need to buy to do it... and how and what compression they should be running at please it would be a big help...

also is there any easier ways at all i dont mind if there is a minor leak i just need to know if there is uno damage cause i had a turbo on a n/a engine. so yeah thanks dude and please write other ways if possible

thanks people

Search around... there are guides and posts about people doing compression tests, and asking the same questions. I can't recall off the top of my head either. Definately it's the best way to check the health of your rings/pistons.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Dredgggggeeee time; I have recently finally started driving the car. It sat for so long that the fuel tank gave birth to rust sludge and blocked my lift pump sock and one of my walbro 460's and left grime, rust chunks and muck all through the surge tank and system. I decided to commit and pull the trigger on an oem r32 gtr fuel tank and Frenchys twin 460 / sender / surge tank hanger combo and all new larger lines and fittings etc, also boost doc heater hose kit / new heater core and a heap of other bits and shits like wideband sensor installed in the dump and Syltech iacv + lines and all wired and added to current tune. now having lightly driven it a couple times without issue, I can happily report on the hta3076 in its current tune. still no boost control switched on, 20psi gate springs, car makes 22psi at 3200rpm in 6th gear with 30-50% TPS from cruise at 100kmh. Going by the old graph, this means it should be making 300-325whp at the same numbers above. Very very responsive setup under true road driving loads. all that's left for the build is body loom + PDM, finish the remote aircon setup, install carbon fibre parts and go for full tune and 30psi. the 315 rear tyres are now performing like they're 195's, wheel spin in any gear at almost any rpm, whereas my previous setup hooked up in 3rd no issue, albeit Nt01's back then / RB25 5spd vs (new) old date r888r's Z34 6spd now, + obviously all the support upgrades I listed in the quoted post above. car sits at 1-3psi on cruise at 100kmh, expectations totally exceeded and I'm beyond stoked with all this so far. IMG_4848.mov
    • I've also been eyeing their rear axles for my car. I purchased seat mounts from them about 7 years ago and they were hot garbage so I've been a little wary about purchasing them. With that being said, please buy them and get back to us haha. 
    • Can a moderator please move this into the right category.. I've accidently put this into racing build thread 🤦🏽‍♂️
×
×
  • Create New...