Jump to content
SAU Community

Recommended Posts

Have owned car for 4 years.

Completely stock with the exception of a rb20 wastegate actuator.

Few marks in the interior and could use a paint job, but other than that its a great reliable car.

Within the last 2 years its had a new water pump and timing belt fitted.

Only reason im selling this is because i also have a r32 and a 300zx, its just not getting driven enough and its a shame to see it sitting there.

The following pics are a few years old now, will get some current ones tomorrow. Same car, just has a bit of paint fade and stone chips at the front.

post-536-1166825010.jpg

post-536-1166825026.jpg

post-536-1166825043.jpg

Looking for 6500. So low mainly due to the fact that it does need a paint job.

EDIT: Forgot to add, its got 140,000 k's on it

Edited by kjb_r33
Link to comment
https://www.sau.com.au/forums/topic/148451-sold/
Share on other sites

  • 2 weeks later...
  • 3 weeks later...
  • 1 month later...
  • 1 month later...
  • 4 weeks later...
  • 2 weeks later...
  • 2 weeks later...

Sold to me,

Thanks Ken,

Going in for a minor Straight and Paint this week, i will send you photo's when it is done.

Drove it home well over 700KM's did not miss a single beat

P.S. the other item is in a post pack waiting for the post office to open tuesday.

Cheers

Link to comment
https://www.sau.com.au/forums/topic/148451-sold/#findComment-3170986
Share on other sites

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Not sure the US can import anything other than the C34 Stagea's, but if you can and you need to to tow, DO NOT under any circumstances get an M35 Stagea. If it is just as a family car and your country/state allows it, absolutely and definitely get an M35 (3.5L if possible as it is effectively a 350Z) over a C34.
    • Punch your VIN (nm35-xxxxxx) into Amayama.com You can see everything there quite easily.
    • Thanks for that, I'll check it all out. I can always do the brakes last anyway if its a problem.  The 16's are super cool, if they do fit I'll cruise around with them for a bit.  
    • Well, that's kinda the point. The calipers might interfere with the inside of the barrels 16" rims are only about 14" inside the barrels, which is ~350mm, and 334mm rotors only leave about 8mm outboard for the caliper before you get to 350, And.... that;s not gunna be enough. If the rims have a larger ID than that, you might sneak it in. I'd be putting a measuring stick inside the wheel and eyeballing the extra required for the caliper outboard of the rotor before committing to bolting it all on.
×
×
  • Create New...