Jump to content
SAU Community

Recommended Posts

Ok, i'm Seriously thinking about a respray for my R33 (It's black). It only has very minor dents

and some kind of paint reaction on the roof. I'm going to get a few quotes today. I

need to know roughfly how much this is going to cost me? just so i have a figure in mind.

Thanks , Kev

Edited by K_E_V_I_N
Link to comment
https://www.sau.com.au/forums/topic/151728-respray/
Share on other sites

respray will cost u anythin between $1500-3k for a basic job.

I'd advise u to spend a bit more and not go for the cheapest option cos after "2 aussie summers" u will have regreted goin for the cheaper option when ur painted is faded and starting to blister and u end up havin to spend the same amount or more again to rectify the paint defects.

mike

Link to comment
https://www.sau.com.au/forums/topic/151728-respray/#findComment-2825291
Share on other sites

respray will cost u anythin between $1500-3k for a basic job.

I'd advise u to spend a bit more and not go for the cheapest option cos after "2 aussie summers" u will have regreted goin for the cheaper option when ur painted is faded and starting to blister and u end up havin to spend the same amount or more again to rectify the paint defects.

mike

Yeah, good point. Went out to get some quotes........ and came back with a sub & Amp >_<

Link to comment
https://www.sau.com.au/forums/topic/151728-respray/#findComment-2825387
Share on other sites

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • A 1.5 way is a 2 way. It is just a 2 way with a less aggressive ramp on overrun.
    • The ABS and/or TCS being missing/broken will not cause the engine to misbehave. It just casues CEL to come on and annoy you. The CEL is useless if it is always on, so you have to do the things you have to do to get rid of it, so it can be useful. Being a Stag ECU, then yes, it will not expect TCS to be present. But it will expect ABS to be present and working. You will need to either make the ABS CU talk to the ECU (don't ask me what that will take on an NA R34), and make sure the hardware is working....or, you just need to blank it out in Nistune. Do not persist with the stock ECU. You will just have problems. Gte it Nistuned. Start from there. DO YOU HAVE A BOOST SENSOR? The ECU's boost sensor that it. It is connected to the loom at the rear of the coil cover. Usually rides on the firewall on an R34, but is usually bolted down to a bracket along with all the other crap at the back of the coil cover when a Neo is dropped into another car. If you do not have it, the ECU will shit the bed. So, do you have one?
    • So sadly the fuel pump etc was not it. The pump and filter is new and it is still cutting around 4000 rpm. A read something about ABS/TCS (engine is from stagea and ECU too so no TCS) and i dont know for 100% that my car has ABS. It has ABS "cube" in engine bay but i dont think it works(or at least from my braking experience). Can be something like that?  I will be driving the car next week to Nistune tuner to properly see what is wrong...  
    • the Tomei LSD fluid with lsd kit. frustrated that it was shaking the car to crap and affecting everything else negatively, I pulled the diff last night, and removed the lsd carrier, could not find anything wrong, however it seem to be 100 locked up acceleration, and deacceleration, wondering if they sent me a 2 way not a 1.5??  either way I installed the stock open carrier back in place. test drove everything smooth as butter again. no shake, shutter, random, what felt like clutch slip and grab or drive shaft play, etc. something differently wrong in side the lsd. I might bother taking it apart (if possible) to figure out what's going on inside this carrier, as bought too long ago to return.  only draw back is its back to a one wheel wonder.
×
×
  • Create New...