Jump to content
SAU Community

Recommended Posts

Has anyone installed 6" component speakers in a R34, i am currently doing my whole new system and decided to put the components in the back as there is no room up the front for all the parts, does anyone have pics of work they have done or had done?

Also nissan have made a damn good car except the fact that i haven't stopped swearing since i started this project cause nothing lines up with the stock system.

-----------------remember smoke tyres not drugs-----------------

Link to comment
https://www.sau.com.au/forums/topic/153481-r34-system/
Share on other sites

just took the whole rear parcel shelf out so could get to speakers then found that the plastic cover over speakers has srews holding them on which you can access through some holes through the boot below the shelf, would of been handy to be able to see them first up, the shelf just clips through to the boot and also under the overlap behind rear seats, also to get my clarions in had to drill out the existing holes to fit new configuration.

i mean really it's not that hard if ya think about it hoo hah ( except for all the swearing)

----------------remember smoke tyres not drugs--------------

Link to comment
https://www.sau.com.au/forums/topic/153481-r34-system/#findComment-2855693
Share on other sites

directly underneath the speakers in the boot there should be a lot of holes in the sheetmetal i'm not sure what ones but there should be four on each side that go th the screws, really hard to see that's why i pulled the whole parcel shelf out it's much easier, there should be two blue clips in the boot and three inside the car behind the rear headrest plus you have to take the 3 bolts out that are for the baby harness points to get the shelf out. hope that helps

Link to comment
https://www.sau.com.au/forums/topic/153481-r34-system/#findComment-2855770
Share on other sites

there are two bolts holding the bottom part of the seat, remove tht. Then just take out the bottom piece seat and the rear there are two bolts as well at both sides, undo those, then lift the back piece as it is hooked on to the frame behind..quite a hassle because they don't fold down :cheers:

Link to comment
https://www.sau.com.au/forums/topic/153481-r34-system/#findComment-2855971
Share on other sites

nice work r34-gtt not that hard once you get it off and see whats going on under there. have my speakers in as well and just fitted the components box and tweeters to the back shelf as well so i'll post pics when it's all back together.

-------------------remember smoke tyres not drugs---------------

Link to comment
https://www.sau.com.au/forums/topic/153481-r34-system/#findComment-2856781
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
×
×
  • Create New...