Jump to content
SAU Community

Recommended Posts

Hi All,

I have for sale a brand new Garrett T51R (GT4502R) 1.22 Ex A/R 75mm comp roller bearing turbocharger that I was to use on my new setup but have once again changed my mind and opted for a new/different setup

This turbo is rated at around 1000hp and is still in the GARRETT box in which I purchased it in

These retail for $2830 + gst

I looking for for $2200ono

-Also have a BRAND NEW 600-300-100 intercooler with polished end tanks up for grabs and im asking for $200ono

Vic Buyers preferred also

So if your looking to save a few $$$ on a brand new turbo/cooler for a killer setup then this is for you

If you require any more information/pics etc dont hesitate to PM

Cheers, shannon 0434 890 939 or pm

Edited by TTWPN
Link to comment
https://www.sau.com.au/forums/topic/161456-fs-garrett-t51r-1000hp-turbo/
Share on other sites

hay mate i rang u on the weekend its dean can u show me some pics thanks. if all goes good i grab it this week

Hey dean,

Mate i can get you pics late 2nite when i get home from work. Plz pm email address

Check on the garrett website if you cant wait till then. This turbo is brand new and has only been taken out of the garrett box once when i had a look at it when it arrived.

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...