Jump to content
SAU Community

Recommended Posts

i'm using a microtech in my 34 gtt at the moment. It's pretty much as they say, a bit rough in the low revs and can be a bit heavy on the fuel.

At the moment i have 250 rwkw and for every 45 litres i throw in i get about 300 km (flog it here and there but mostly highway driving). Not the best fuel economy i've seen.

Would probably go the power fc if you can. The only reason i went microtech is because that's what my tuner prefers to use.

Link to comment
https://www.sau.com.au/forums/topic/163005-microtech/#findComment-3025367
Share on other sites

i got a microtech in my 32 GTR

and i am getting 400k's to about 60L and im still to truely finish tune (bit rich for now)

so a little over 300rwhp and approx 15L/100k

true not as good as Power FC in economy as no closed loop

but is by no means BAD fuel economy

ECU choice should all depend on tuner

RellikZephyr

Link to comment
https://www.sau.com.au/forums/topic/163005-microtech/#findComment-3026065
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • The spray cans were in the "Kiln" room whilst I was preping the parts,  so probably around 2 hours to get them warmed up, the kiln room has 3 small ovens running at 100°c, 3 medium sized ovens running 100°c, and the large one I used running at 80°c, the room itself was about 28°c, I also spent a bit of time taping up the parts in the room as well, and by the time I was done I would assume that the parts were around that 28°c As for power, I expect a couple of Killerwasps up high would be achievable with the current mods, I'm still running the MZR 2.0 intake and throttle body, and there is a slight mismatch with the 2.0 intake (smaller) and 2.5 intake ports (larger) on the head, this intake is matched and specifically designed to fix this issue with the ports mismatch, the throttle body is also a couple of mm larger, OEM is 65mm, the Bosch is 68mm In the end it will look "prettier" than the molded plastic thing that is the OEM MZR 2.0 intake As for the LSD, it's the OEM Torsen which works fine for what I use the car for, plus, basically no maintenance apart from the occasional oil change
    • I was at Tunehouse in Marrickville (great team over there really know their VR's) , and I spotted this Very clean R35.  
    • Mate , I have the same issue right now with the exhaust noise , if you can tell me what your local guy did , I'll talk to my guys and see if they can do the same. Power is good but it just too loud when put it down. 
    • The other trick I've found with wrinkle black is to put the can in hot water for a bit to warm the paint up, and to pre-heat whatever you're painting. It'll be interesting to see if you pick up any power with the intake, following with interest. Got a proper lsd for this?
×
×
  • Create New...