Jump to content
SAU Community

Recommended Posts

SOLD PENDING PAYMENT

Hey,

I have for sale a Nokia 8800 that has been used for i think 2 years.

Reason for selling is my plan letys me upgrade to a new phone as plan has now expired. I have bought a 3G phone so need to hold on to my old phone.

Price is $150 bank transfer plus postage.

Reason why it is cheap is because it has been used well for the last few years. So it has surface scratches front and back and a small crack on the bottom right hand side.

So give me your thoughts, i have been honest about the condition and still works for my daily use (more txt messages than calls).

Comes with full charger pack including stand up charger and spare battery. (please see photos, i apologise but were taken by my new phone)

post-25223-1183789285_thumb.jpg post-25223-1183789761_thumb.jpg post-25223-1183789792_thumb.jpg post-25223-1183789836_thumb.jpg

Thanks and if anyone is interested please let me know via PM.

Jake

Edited by jakegts
Link to comment
https://www.sau.com.au/forums/topic/175665-fs-nokia-8800/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I think he was only proposing to use the wire, not the sender. Simply because it runs from the right place to the right place. Personally, I wouldn't hack up the factory wiring like that. I'd just lay in the Defi loom.
    • From memory it wasn't too hard to simply see which wire ran where when you plug that in. Unfortunately also from memory the OEM sender does not use the same configuration 99.9% of gauges run. So in other words if you connect the signal wire that was running to the OEM gauge to your DEFI gauge you might find your oil reads at 200C or some other incorrect value. I remember having the same line of thought and then running new wires/senders to match the gauges I have. The pinout is available in the R34 workshop manual.
    • Does anyone on here know which wire on the GTT triple gauge pod harness is for the oil temp gauge? my sensor works fine but I upgraded the gauges to DEFI advance. And if I can simply piggyback off the oem oil temp wire to the Defi oil temp sensor wire that would make life so much easier. 
    • Even face her a wash now that’s it worth more than my house
    • This was what I was invisioning, or Pete cutting a beer can up and hose clamping it around the catch can! Ha ha ha
×
×
  • Create New...