Jump to content
SAU Community

Recommended Posts

hey all

i went and saw the movie on thursday and in my opinion it wasnt any better than the 1st although it is one of those must see movies.

for those that have seen in , what are your opinions?

mine, well i think the evo n eclipse were nice though nothing to toss over, n it would have been nice to see more r34 n that sexy viper, although i prefer a stock r34 gtr front bar to the c-west kit.

anyways im not gonna say anymore 4 those who havnt seen it.

just when u thought that tfatf couldnt get more unrealistict.

Link to comment
https://www.sau.com.au/forums/topic/17708-2-fast-2-furious/
Share on other sites

errr i dont think a movie like this is worth critiquing, it was good for the perve on the chicks and cars ... and thats about it :)

as for seeing more of the 34, i agree, but thats what sponsorship does ay!? money talks!!!

i would've like to have seen more evo action if it wasnt so farken riced up! shocking. the r34 riced up looks good, the evo riced up looks just like a lancer with fibreglass!

Link to comment
https://www.sau.com.au/forums/topic/17708-2-fast-2-furious/#findComment-367815
Share on other sites

Guest Devilish Angel

lolz...

nice...

and to do with the movie..

mate.. i totally died when i saw that r34...

i was sittin der.. it came on and my first reaction was *melt* whatta hunni...

it lookz sooooo good.... i think that was the best part of te movie.. and honestly the 1st movie had a "better" story line.. but i much prefer the 2nd for the races the the r34

Link to comment
https://www.sau.com.au/forums/topic/17708-2-fast-2-furious/#findComment-369094
Share on other sites

Guest
This topic is now closed to further replies.


  • Latest Posts

    • Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
×
×
  • Create New...