Jump to content
SAU Community

Recommended Posts

Need this stuff gone, so if you think your grandma might like it for xmas take it away!

I'm in Toowoomba QLD pickups welcome, otherwise postage paid by buyer.

FREEBIES - Take the AC control unit and panel filters with any purchase.

Please PM me rather than posting here.

Looking for a passenger side mudguard too, the piece that fits under the front bar.

-----------------------------------------------------------------------------------

2 x Stock Airbox filters, couple weeks on one, zero on other ... $30 both

filterstk3.jpg

Front RH S1 Coupe Headlight, grille brackets removed, no bulbs otherwise good no cracks ... $30

headlightjx0.jpg

2 x Stock S1 intercoolers + bracket + pipe - bout 30XXX k's VGC... $40 each

ic2qk0.jpg

ic1zr6.jpg

*Note long return pipe not included

Intercooler funnel/duct ... free if you take an intercooler

Full stock exhaust with dump and newish looking cat, post compliancing ... $80

exxymf9.jpg

AC Control Unit perfectly functional, lower buttons not quite firm ... $20

acnb7.jpg

STOCK TURBO INTAKE PIPE - $30

Edited by vault13
Link to comment
https://www.sau.com.au/forums/topic/178003-r33-various-stock-bits/
Share on other sites

I did, $30 at wow gets you a nice universal DIN pocket :)

hey i dont suppose you have a single din space thing also? i have a big hole in my dash from when i removed my tv:(

thanks.

No cracks that I see, got through compliancing fine glass pane just needs a good clean.

Auspost site says about $20 to box it up to Sydney mate.

any cracks on the headlight? how much postage to sydney 2170?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...