Jump to content
SAU Community

Just Hooked Up The S-afcii On A S2 R33 Gts-t And The Car Runs Like A Dog With Three Legs....


Recommended Posts

for r33 skyline gts-t (rb25det) settings: 1.hotwire,

2. 1 in 1 out.

is that ok? or not?

sensor type hotwire, sensor NO. 04 04. and sensor cal. 01 01.

sensor type hotwire, sensor NO. 04 04. and sensor cal. 01 01.

hi again. ) here is my settings. first screen: NOTWIRE. second screen: in 4 out 4 . and next screen: sngle / single.

is that write yas? or not correct me please. thanck you again

hi again. ) here is my settings. first screen: NOTWIRE. second screen: in 4 out 4 . and next screen: sngle / single.

is that write yas? or not correct me please. thanck you again

thats right

  • 1 month later...
hi again. ) here is my settings. first screen: NOTWIRE. second screen: in 4 out 4 . and next screen: sngle / single.

is that write yas? or not correct me please. thanck you again

Ive just noticed the same problem on my car. I had a look around at all the fluids and noticed that my coolant was low. but i havent filled it yet. gotta buy some first thing tomorrow morning. then ill tell ya what happens. I have a 32 GTR so things could be different.

yeap thats correct..

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Despite the level up question, actually I do know what that is....it is a pressure sender wire.  So check out around the oil filter for an oil pressure sender, or maybe fuel pressure near the filter or on the engine. Possibly but less likely coolant pressure sensor because they tend to be combined temp/pressure senders if you have one. Could also be brake pressure (in a brake line somewhere pre ABS) but maybe I'm the only one that has that on a skyline.
    • Pull codes via the self-diagnosis procedure. As far as I can tell this is just a sign of transmission issues but not a code unto itself.
    • Hi All, putting the engine back together and everything is perfect except have this plug left over.. any ideas what it is for and where it goes? Is on cold side under the intake plenum *note not a stock plug, as everything has been modified Cheers
    • Sounds like a misfire. Check fuel pressure and don't even think about going into boost while it's like this unless you enjoy engine rebuilds.
    • Just. Gasping. Here. Just. Gasping.
×
×
  • Create New...