Jump to content
SAU Community

Recommended Posts

Where is a good place to look for R33 caliper bolts? I'm scared the dealership will rape me :D

I don't think wreckers would part with the bolts from the calipers would they?

Where is a good place to look for R33 caliper bolts? I'm scared the dealership will rape me :D

I don't think wreckers would part with the bolts from the calipers would they?

i rang them fo yo lazy ass

quoted an R33 1996 2wd hicas front caliper to knuckle bolt, $6.50, 1 in melb, otherwise its japan.

Hey people,

I'm looking at buying or building a house and I need some opinions.

Do you think its best to buy an older not so nice house on a 600-700square meter block Or...

Build a house through Devine homes for the same amount of $ but have a 300Square meter block and have less room to move...but be in a brand new estate across from a creek/reserve

Where is a good place to look for R33 caliper bolts? I'm scared the dealership will rape me :D

I don't think wreckers would part with the bolts from the calipers would they?

Coventry Fasteners if you know the dimensions and thread. Mate got some off em for his calipers, make sure they're high grade ones though.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Hello Liam - HA - somewhere in flies - possibly I have an update, but I have been so busy, projects have taken a back seat to getting business back on track.  I will let you know the outcome, but I think I am going to go for the 8HP,  CHEERS.  ELVIS
    • Thanks Joshuaho96, yes - as someone else also suggested, the 8HP seems the 'smart choice' - HA - and ZERO to do with cost, but I am sure 8 speeds will be better than 6 speeds - HA - maybe.  I will purchase a new 8HP,  Thanks.  ELVIS.
    • Nobody said anything about getting a "...cheap Falcon box..."- it was JUST a question about a specific transmission.  And YOU may have a problem with not enough $ - HA - I do NOT - so please keep your comments like you are some financial guru to yourself.  BUT - much appreciated re the cost of a new 8HP and I twill probably be the way I go.  Thanks.  ELVIS.
    • Most people I know in the BMW world are swapping 6HPs for 8HPs. The 6HP has a big issue with one of the clutch drum bushings wearing out shockingly early which leads to them going into limp mode going into 5th/6th gear as the oil pressure loss from the worn bushing causes clutch slip. Even with the adaptations in shifting the TCU can't bump line pressure enough to keep the clutches from slipping and burning. I've personally looked at a 335d with 6HP28 with one owner and ~90k miles on it and the transmission adaptations were way out of spec and even though it nominally drove ok I'm confident it would have needed a full rebuild sooner than later. Other than that they're fine, but the 8HP doesn't really have weird issues like this to my knowledge and they're in everything these days so pulling them out of crashed cars isn't too hard.
    • There is an ABS pump and a few solenoids. You could trigger the front/rear solenoids with a pressure bleeder attached with a Consult 2. 
×
×
  • Create New...