Jump to content
SAU Community

Looking For Replacement Boot For Handbrake & Gear Shifter

Marko R1

By Marko R1,
in Exterior & Interior Styling

 Share

Recommended Posts

Marko R1 Grand Master

Marko R1

Posted
Posted

(i have added the same post under 'general maintenance')

i am looking for replacement boots for my handbrake & gear shifter - preferable leather OR if not leather then i'd be happy to change just the handbrake boot in the factory vinyl so it matches the gear shifter.

where can i source this? i have searched all over the forum

regards,

Baconer Grand Master

Baconer

Posted
Posted

I got a pair from a seller on eBay in England. Real leather and your choice or colour scheme (i chose white and black). Name was Mr Gaiter but no longer registered user, pretty sure he is on there with a different name, foudebuzi or something

Marko R1 Grand Master

Marko R1

Posted
  • Author
Posted
I got a pair from a seller on eBay in England. Real leather and your choice or colour scheme (i chose white and black). Name was Mr Gaiter but no longer registered user, pretty sure he is on there with a different name, foudebuzi or something

i think i found gaiters - is this it?

http://cgi.ebay.com.au/NISSAN-SKYLINE-GTS-...bayphotohosting

ForevaZero Enthusiast

ForevaZero

Posted
Posted

buddy your link doesnt work...

i brought a set of handbrake and gear shifter boot of ebay from gaiter for my r32 gtst..

fits perfect with some minor adjustment. has the wiring at the bottom of the base as well. saves u time from taking it out of your old one...

its leather and makes the car look like new...

Marko R1 Grand Master

Marko R1

Posted
  • Author
Posted (edited)

here it is as per image!

not sure if i should go with the GTR emblem or plain black leather...also comtemplating on black stitching or red stitching, thoughts?

post-8728-1203492891_thumb.jpg

Edited by Marko R1
bigslick Collaborator

bigslick

Posted
Posted (edited)

Here you go, this is the one you want.

Gaiter boots

I got these and they are very good quality.

Just make sure you specify exactly what car it's for and what colour leather and if you want the logos or not.

EDIT: Damn, just beat me :rofl:

GT-R logos are ok, if I got them again I'd just get the logo on the handbrake.

Edited by bigslick

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • LaurelPWR
      Forced Performance Hta Turbos

      By LaurelPWR · Posted

      Dredgggggeeee time; I have recently finally started driving the car. It sat for so long that the fuel tank gave birth to rust sludge and blocked my lift pump sock and one of my walbro 460's and left grime, rust chunks and muck all through the surge tank and system. I decided to commit and pull the trigger on an oem r32 gtr fuel tank and Frenchys twin 460 / sender / surge tank hanger combo and all new larger lines and fittings etc, also boost doc heater hose kit / new heater core and a heap of other bits and shits like wideband sensor installed in the dump and Syltech iacv + lines and all wired and added to current tune. now having lightly driven it a couple times without issue, I can happily report on the hta3076 in its current tune. still no boost control switched on, 20psi gate springs, car makes 22psi at 3200rpm in 6th gear with 30-50% TPS from cruise at 100kmh. Going by the old graph, this means it should be making 300-325whp at the same numbers above. Very very responsive setup under true road driving loads. all that's left for the build is body loom + PDM, finish the remote aircon setup, install carbon fibre parts and go for full tune and 30psi. the 315 rear tyres are now performing like they're 195's, wheel spin in any gear at almost any rpm, whereas my previous setup hooked up in 3rd no issue, albeit Nt01's back then / RB25 5spd vs (new) old date r888r's Z34 6spd now, + obviously all the support upgrades I listed in the quoted post above. car sits at 1-3psi on cruise at 100kmh, expectations totally exceeded and I'm beyond stoked with all this so far. IMG_4848.mov
    • Shizu
      Sheraaz's R34GTT Build

      By Shizu · Posted

      Thanks mate.
    • TurboTapin
      Crank Motorsports Front Axles

      By TurboTapin · Posted

      I've also been eyeing their rear axles for my car. I purchased seat mounts from them about 7 years ago and they were hot garbage so I've been a little wary about purchasing them. With that being said, please buy them and get back to us haha. 
    • Shizu
      Sheraaz's R34GTT Build

      By Shizu · Posted

      Can a moderator please move this into the right category.. I've accidently put this into racing build thread 🤦🏽‍♂️
    • Shizu
      Sheraaz's R34GTT Build

      By Shizu · Posted

      Being a manual, we very quickly ordered new R34 gearbox (From Nissan) and remaining parts from Kudos motorsports. Would highly recommend the team there. Ultra helpful and quick to share advice and upgrades. We are in the middle of taking the Auto out (Genuine 94,000/kms) and putting the Manual in this weekend. Part 2 of the build will include likely a Plazaman Intercooler and Plenium, Hks Exhaust with Tomei Dump (ordered).
×
×
  • Create New...