Jump to content
SAU Community

Recommended Posts

Heyaa all,

Im gettin my SAFC II Tune really soon, and read soo much bout a/fuel ratio, lots of people giving me all sorts of figures

from 11.5:1 - 12.5:1.

So pretty simple question,

I want my car to be on a safe tune, so if i were to go out on a cold nite and it lean out a little, it'll still be safe. ( I go out at night heaps )

Mods are as followed:

R33 S1.5

Stock Turbo @ 10psi ( no boost controller )

3" Turboback with no resonators

Pod with shield ( no cai )

Greddy Front mount

SAFC II

Walbro Fuel pump

So from what i gathered from the forums is this wat the a/fuel ratio should be:

Full Throttle - Below 4500rpm - 12.5:1

After 4500rpm - 12:1

Lo Throttle - 14.5:1

With these a/f and my mods you guys recon i will make 190-200rwkw ? Reliablely ???

I never seen partial throttle been tuned on a dyno before ? I only seen WOT power runs, So how do they do it ? Just wanted to know for knownledge sakes.

Any help and advice would be really greatful !

keep in mind you may not get a 12:1 on a safc. you may have to settle for an 11:1. its about finding the balance with a safc.

the more fuel you have to take out of the map (or the more you bend the afm signal), as is the case with most 33's, the more it screws with your timing aswell. take out too much fuel and your ecu may retard the timing too much and you will get knock.

yeah i got an apexi neo afc..

ive had mine tuned wice to get it right, but then i lowered the % of the low throttle..

to increase fuel eco...lol but got it all good..

i get lik 400-500k's outa my tank..

but i change on high-throttle around 2500-3000-3500rpm.. i made 0 % which means no change by the afc/neo

on idle my car is -12% on the a/f ratio %'s..

but its a great product and recommend..

but stil get an aftermarket ecu...

really depends on your usage .

street use then 14.7:1 - 15:1 cruise and 12.5 :1 for full throttle

if using on track then 11.5:1 - 11:1 for full throttle .

if its too lean at 12.5:1 on the track under full throttle conditions than you will produce to much heat and cause undue pinging and under bonnet temp will be significally higher. (known from experience )

but yes you are on the ball park with the ratios that you where given

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • About $4k brand new, available from vendors in Oz, or via an importer from Japan. Although that is for an R34 box, so you also need to buy the push clutch front plate (brand new from Nissan) and swap that over, and drill the bellhousing for a push clutch slave cylinder.
    • Absolutely could be. I collected data logs from when the O2 sensor was still out and also after I had replaced it so will try to compare them. Pretty confident that the affect is lowered with the new sensor, will check logs at the same RPMs/conditions. 
    • Hey guys Long time lurker, I daily a nm35 stagea 250t rs four and I've had it for almost 2 years (very reliable 👌). Issues or just looking for information ill always find myself here having a read, so thought id join.  3inch stainless intake, pod filter, AM performance turbo dump pipe, 3inch hotdog, 3 and half inch stainless to 3 and half inch AM performance blast pipes. Bc racing coilovers. 18inch rims Hdi intercooler and trans cooler soon.  Here's my car
    • thanks for the advice on the box... i was thinking the 6 speed was better for cruising on the highway but on closer inspection and comparison the Rb 5 speed box was not too different...  So the choice is going to be the RB25 box... if I can save up and find one at the right price  
    • Thanks Matt, yes that's what i am aiming for. Just going to apply the right voltage and grounds to the dash connector. Hence my search for these pins... any chance you know if these pins are in the same spot as the ones on the S15 Dash connector? as mentioned above on page 8?
×
×
  • Create New...