Jump to content
SAU Community

Recommended Posts

as above..

I don't like the aftermarket one that came with the car.

Just prefer a stock series 1 steering wheel.

I can even swap for the one that is in my car with boss kit too if someone is interested (can get pics if anyone is interested.)

Don't want any tears on the wheel.. I know it's rare but there must be some around.

thanks

Link to comment
https://www.sau.com.au/forums/topic/213108-wtb-stock-series-1-steering-wheel/
Share on other sites

I can even swap for the one that is in my car with boss kit too if someone is interested (can get pics if anyone is interested.)

this is why I want to swap/replace..

if this is what someone is interested in then by all means.. lets swap.

post-343-1207128585_thumb.jpg

no shit.. so you got one you want to sell or swap for this masterpiece-o-shit?

afraid not I like my stock steering wheel. Its starting to look a little worn out though. Anyone know if they can be re-trimmed?

this is the wheel

http://www.skylinesaustralia.com/forums/in...t&id=129387

pass on your one thanks

$80 firm + post or you are welcome to pickup.



  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.  
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...