Jump to content
SAU Community

Recommended Posts

I've got a 93 model and I know mechanically it's got the later pull type clutch just like the 33 GTR, in comparison to the older model 32's with the push type.

Also found out today that the later 32's came with the 33 crank, im still unsure of this and would really like to know further details.

Link to comment
https://www.sau.com.au/forums/topic/213585-r32-gtr/#findComment-3772702
Share on other sites

93 gtr has a stronger crank and the pull type clutch than the 89/90/91/92

later in 93 came the V Spec then in 94 came the V Spec II ( V Specs came with 17 x 8 rims compared to normal gtr 16 x 8) i think

Nismo prepped N 1 32 GTR came without stereo air con etc to reduce weight and also no grille in front of the intercooler

Link to comment
https://www.sau.com.au/forums/topic/213585-r32-gtr/#findComment-3772721
Share on other sites

late 1992 they went to pull type I think.

Crank strength is not an issue with the earlier crank, it's the oil pump snout on the crank. Too short to engage pump gear properly and tends to be a weak link in the chain....

Also headlights are slightly different between earlier and later 32's, side intrusion bars were standard too in the later cars.

There are a few topics kicking around with plenty of information on the differences.

Link to comment
https://www.sau.com.au/forums/topic/213585-r32-gtr/#findComment-3772808
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...