Jump to content
SAU Community

Recommended Posts

Due to some issues that would take too long to explain, my ebc was never properly tuned... So I was just wondering if there's anyone out there with an R34 GTT who runs 11psi boost and what your settings are

ie. what 'percentage' is the boost setting, what about the 'gain' and 'set gain' settings ? Cheers

Link to comment
https://www.sau.com.au/forums/topic/226259-greddy-boost-controller-settings/
Share on other sites

Yeah I had similar (except 'set gain' was '94') and it seems to be hitting 12 psi after I got my actuator fixed recently.

When you say 0.65 set gain you mean '65' (as in 6.5psi) right or was your controller using the 'bar' measurements ? That seems a bit low though if it's in PSI doesn't it? I thought the 'set gain' value is supposed to be as close to the peak boost as possible.

Anyone know the right way of setting the 'set gain' value??

Edited by Delta Force

yeah same controller it's just that I've switched mine to PSI mode. Speaking of which, 0.65 bar is the equivalent of 9.4psi which is what I also have.

But I don't want to run 12psi as it's way too risky with the stock turbo... so I'll need to tweak it again.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • just an update to this, poor man pays twice  Tried sanding down the pulleys but it didnt do the trick. Chucked another second hand alternator in the na car which I got for free off my mate and its fixed the squelling. Must have been unlucky with the bearings.    As for my turbo car, I managed to pick up a cwc rb alternator conversion bracket + LS alternator for 250 off marketplace, looked to be in really good nick. Installed it , started the car and its not charging the battery.... ( Im not good with auto elec stuff so im not sure if this was all I needed to do but I verified such by using a multimeter on the battery when the engine was running and I was only getting 12.2v )   I had to modify the earth strap for the new LS alternator , factory earth strap was a 10mm bolt which did not fit the bolt on the LS alternator which was double the size so I cut it off , went to repco bought some ring terminals that fit, crimped it onto the old earth strap and bolted it up to the alternator , started the car and same issue. Ran like shit and was reading 12.2 at the battery.  For a "plug and play" advertised kit thats not very plug and play but alas.  My question is , am I missing something ? Ive been reading that some people recommend upgrading the stock 80 amp alternator fuse to a 140 amp but I dont see how that would stop the alternator charging especially at idle not under load.  Regardless ive pulled it out and am going to get it bench tested by an auto elec tomorrow but it would be handy to know if ive missed something silly or have done something wrong.   
    • My wild guess is that you have popped off an intake pipe....check all of the hoses between the turbo and the throttle for splits or loose clamps.
    • Awesome, thanks for sharing!
    • To provide more specific help, more information is needed. What Android screen? What is its wiring diagram? Does the car's wiring have power at any required BAT and ACC wires, and is the loom's earth good?
    • So, now all you need to do is connect the 2 or 3x 12v feeds into the unit to permanent 12v, ACC 12V and IGN 12V that you can find in the spot behind the stereo, and the earth, and then it will switch on with the car.
×
×
  • Create New...