Jump to content
SAU Community

Recommended Posts

hello all, my r33 keeps blowing park fuses ive searched the web for a wiring diagram but all i can find is engine management and computer related stuff ive downloaded the nissan r33 engine service manual but thats no help, does anyone know where i can get the diagram i need , does anyone know if r33s have a common fault with parkers? i had to ask you never know. :rofl:

Link to comment
https://www.sau.com.au/forums/topic/229862-r33-wiring-diagram/
Share on other sites

Oh... do ur inside and outside ones work? or no park lights at all? to they turn on when u put your low and high beams on? Could be the switch

no park lights at all only high and low, i have brake lights thats all,i have front and rear blinkers,i unpluged the front and rear lights also the number plate lights but when i turned the switch on the fuse blew instantly also the buzzer that tells you the door is open dont work :worship:

Just looked through my manual but the same no wiring other than engine controll. If you like you can bring the car around to me and I can try and find the fault for you, could only be in a few spots.

Cheers

Ross

i would like that :sick: where do i bring the car to?

  • 4 weeks later...

i fixed the problem,and yes it was the earth to the stereo ,i fitted a stereo a few weeks before but the problem only just recently happened :)

hey mate i had a similar problem with my fuses blowing all the time found out that it had to do with the stereo earthing the wrong wire have a look around there

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...