Jump to content
SAU Community

Trust I/c, R34 Gtr Fuel Pump, Door Release Kit, Ebc Pads, Braided Lines, Wiring Loom, Suspension Goodies And More!


Recommended Posts

Items described below are all for sale, most are negotiable. I am willing to organise swaps or swaps with adjustments with any of the parts for the following -

Electronic Boost controller

Coils / Suspension to suit R34 GTR

BOVS / Hard Pipe kit to suit R34 GTR

Clutch to suit R34 GTR

Other performance parts of interest, PM me.

1. Trust V-SPL Intercooler Kit

Off my old R33, used for about 15000 KM's. Good condition apart from one small ding at bottom of cooler, has not crushed the entire row but has bent in fins above it slightly. Have been told this won't have a drastic effect on the coolers performance. Comes with all the piping etc to suit an aftermarket front facing plenum arrangement.

Chasing - $750

post-4555-1221447099_thumb.jpg post-4555-1221447108_thumb.jpg

2. R34 GTR Fuel Pump

Standard pump out of my GTR, perfect working order.

Chasing - $150 Posted

3. Full remote door popper kit (Brand New)

Bought a full kit for my R33 GTS-T to have the remote door pop thing happening. Comes with wiring guide, poppers, motors, remote controls and backup buttons etc. The poppers were upgraded to the stronger ones so they could easily handle coupe doors.

Paid - $350. Chasing - $250 Posted.

post-4555-1221447081_thumb.jpg

4. Front braided lines to suit R33 GTS-T (Brand New)

Bought for my R33 and never used, made professionally at brake shop.

Chasing - $125 Posted.

post-4555-1221447062_thumb.jpg

5. Noltec adjustable camber kit for R33

Brand new in the packet, also bought for my R33 and never used.

Chasing - $125 Posted.

post-4555-1221447044_thumb.jpg

6. Noltec sway bar link bush kit

Brand New.

Chasing - $20 Posted.

post-4555-1221447028_thumb.jpg

7. R33 GTS-T Bush kit

Brand New.

Chasing - $110 Posted.

post-4555-1221447008_thumb.jpg

7. EBC Green stuff Brake Pads (DB1170)

Brand new, bought and never used.

Chasing - $350 Posted (Full Set)

post-4555-1221446988_thumb.jpg

8. Cusco Strut Brace suit R33 GTS-T

Bought and never used, brand new in packet.

Chasing - $150 Posted

This Product is now $245 Delivered from Nengun - http://www.nengun.com/cusco/strut-brace-type-os

R33 GTS-T interior wiring loom! Complete!

Bought to redo my car, never used it! Fantastic condition!

Chasing - $170 Posted.

post-4555-1221446947_thumb.jpg post-4555-1221446955_thumb.jpg post-4555-1221446964_thumb.jpg

Racing Hart Type CX 19" w/75% Rubber.

Bought off a member here for my R33, they have been put on the car but the car never ended up going so technically never used since i bought them. They have some very light marks / scratches on them. Most can be polished out. Come with centre caps, very high quality wheel. Tyres are hankook, can take closer pics upon request. Specs are 235's on the front, 255's on the back and i have been told the rear can take wider tyres then those.

Chasing $2500 or swaps for 19" Rims / Tyres to suit GTR. Must be jap branded and am willing to supply cash adjustment.

post-4555-1221446846_thumb.jpg post-4555-1221446858_thumb.jpg post-4555-1221446869_thumb.jpg post-4555-1221446901_thumb.jpg

Edited by Got Boost?
Are the braided lines both front and rear??? if its front and rear ill take it

Sorry just front mate, corrected it.

Prices are NEG. Make an offer! Will trade intercooler for electronic boost controller (AVC-R or Similar)

Price Drops!

1. $600 Neg

3. $200

4. $100

5. $100

7. $100 (Bush Kit)

7. $300 (Pads)

Wiring Loom - $150

!

Edited by Got Boost?

hey mate have u got a pic showing how the IC pipe runs through the engine bay? do u still have the original crossover piping or did it get chopped n welded for the frontfacing plenum? very interested

...on second thoughts would u sell the core alone as well?

  • 2 weeks later...
  • 3 weeks later...

hi

u sellin just the pump or the whole cradle that the pump sits on aswell?

also do u no if this would fit an r33 gtst?

cheers

  • 4 weeks later...

BUMP!! Still taking offers on everything! Nothing ridiculous though..

  • 1 month later...

hey dude, where abouts in brisbane are you and is the intercooler still available? will that support a standard BOV?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • sold listed as a Tomei LSD 1.5 Way For 1998+ Nissan Skyline ER34 25GT RB25DE w/Open R200 https://www.ebay.com/itm/174006114594?campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=&mkrid=711-53200-19255-0&loc_physical_ms=108689&loc_interest_ms=&campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=71883f2ccc571356e0a757bc7adfdde2&mkrid=710-53481-19255-0&loc_physical_ms=108689&loc_interest_ms= it went in like butter all gears, alignment, back lash etc, rotation and clearances correct, and if rolling all rotates smooth and free when coasting down road , clutch in or out over 10 mph smooth... its the binding, clunking and jerking from a stop that is most concerning, also seems like its going to tear the tires off in 10 miles of normal road driving. 
    • What 1.5 way? There's no such thing really as a 1.5 way, just different ways of explaining 2 ways with different ramp rates. HOWEVER. In any driving in a straight line your 1.5 or 2 or 1.7 way should have no clunking at all. With the clutch fully depressed the diff should be silent (unless it's welded but I'm assuming it's not). Something aint right here.
    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
×
×
  • Create New...