Jump to content
SAU Community

Recommended Posts

  • Replies 51
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

either way, they undid the wrong doings of another cop, in my books that deserves praise. but noone praises the cops when they do good, everyone just shoots them down when they do 'bad', if doing your job is a bad thing.

off topic, your car looks sick in your sig.

Yeah true, the cop could of just told him to shove it and make him waste his money and time taking it to regency but they undid their wrong and got someone to come out to re-check and remove the defect sticker.

oh and cheers ;)

hey cubes are those heights for r33 as well or just r32

R33 and R32 have different heights, also it makes a difference if its turbo or N/A.

Best bet for any defect is to contact regency to confirm actual requirements!

does anyone know if the R34 heights have changed ?

or is it still a 32km gap between centre wheel and arch.

errr do you mean cm a km is a long way

Edited by mid life crisis
does anyone know if the R34 heights have changed ?

or is it still a 32km gap between centre wheel and arch.

I'd like to know too.

Although I went through without problems with 350 front 350mm rear.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • That looks good, but I think you're going to need much beefier side skirts now.
    • They are daft and there's a reason it never caught on. Steering feel? We don't need no stinking steering feel!
    • I gotta pull you up on this. It's driving me crazy. A shutter is something that closes, like over a window or in a cmera. The word you want is shudder. That LSD is clearly f**ked. Take it to a diff shop and get it disassembled and examined by an expert. YOu might have plates welded together or something equally crazy.
    • Define "starting to fail". Wy not just rebuild them?
    • Check the Nistune doco. There are a few assumptions being made here that might not be valid. I will list the things that occur to me: Base map. Base map for what? Base map for Z32? Then the cranking pulse width is probably wrong for an RB25. The extra 500cc of capacity might well be enough to prevent it from catching. Base map for RB25? I don't think you can load one of those into a Z32. You have to just make the settings correct for an RB25 in the Z32 base map. That is either K or the TIM to get the pulsewidth right. Loom. You bought a loom for an RB. And you plugged it into a Z32 ECU. Did you make sure that any iwre differences were swapped. From memory, there's at least a couple. And as per the others, I would suggest making sure that the fuel pressure is correct while cranking and that the injectors are actually flowing as expected. They really must come out and go on the bench, unless you do find that you have messed up as per above points. I would also suggest watching in Nistune to make sure that everything is reading correctly. That the correct binary flags are raised at the right time (like the crank signal), that there's no stupid values in K or TIM. That you have not got mismatched firmware for the ECU and/or a wrong image loaded.
×
×
  • Create New...