Safc Sensor Voltages

[Travo]

Hi guys,

Well i have installed my safc following preds guide (in diy section) and my safc powers up and car seems to idle fine..

BUT

going through the monitors i noticed nothing seems to be moving except RPM. My AF meter isnt moving off 0 and neither is the throttle. Another thing is it cannot rev past 2500rpm. It just revs up to and bounces on 2500.

I have reset everything to factory settings and put it to standard R33 25t settings. I am fairly decent with wiring and it is exactly as done in the guide (have checked way to many times..) so i dont think that is the problem unless the pin outs are different in my car?

My sensor check in safc says my int1=0.01 int2=0.01 and thr=0.04

Can anyone with a safc verify these are correct?

car=r22 gtst s2

Your thoughts please

[simpletool]

Int 1 should be the AFM, the voltage at idle is around 1.1V.

The fact your car only revs to 2500rpm from memory means that it cannot find a signal from the AFM.

Did you cut the AFM wire, run it into the SAFC then back out of the SAFC into the ECU?

Throttle is also usually 0.4V not 0.04V I think. (I don't look at this very often).

Clearly the wiring is wrong or the SAFC is busted.