Jump to content
SAU Community

Recommended Posts

r33 gtst with r32 rb26. motor has been rebuilt in November last year done 1500km since. rego till Sep 09, cost $9500 for rebuild

rebuild involved

arias pistons

billet rods

metal head gasket

N1 oil and water pump

head shaved and valves reseated

block decked

full ballanced bottom end

nismo turbos apparently bigger than N1 $1700

sump buffle,

big dump pipes

SARD fuel reg

bosch 044 fuel pump

car has gtr Dash

coil overs

Running good and 15psi guessing around 300kws at the wheels mayb little less

car needs body work mainly just paint job will need to see to notice

please no time wasters genuine sale

$16500 offers welcome. 0411672105

post-52687-1233831949_thumb.jpg

post-52687-1233832021_thumb.jpg

post-52687-1233832071_thumb.jpg

also has ARP head studs, boost contoller, strut brace, only needs ecu and injectors and this motor will be putting out great power. big stainless steel front mount oil cooler. neg on price need sold buying house got to get rid of personal loan.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...