Jump to content
SAU Community

Recommended Posts

Got my 1996 Series 2 M-Spec for sale, 170 000 on the clock. May cosider Swap for something else, possibly cash my way depending what it is. :)

Mob is: 0430 349 254

Located : Brisbane

asking $13 000 ONO

Email: [email protected]

gearbox and diff oils done approx 10000 ago

clutch fluid done 3 months ago

Brakefluid (dot 5) - 6 months ago

Powersteering fluid - 6 months ago

New Cooland - 6 months ago

New timing belt/Pullies - 1 yerar/20 000km ago

New Fan and A/C Belts - 2 months ago

Rocker cover gaskets - 6 months ago

Upper Engine cleaned - 6 months ago

3" Jasma Aproved Turbo Back Exhaust - complies to the law -under 86 db!

Monsta FMIC - only installed 2 weeks ago

Apexi SAFC (Super Air Flow Controller)

Exedy Racing Clutch, 8 puk ceramic material with over 1 ton of clamping force.

Drift Power intake pod filter, enclosed by a Custom fibreglass cold air box to make it legal, and gain more power.

Red Silicone Vacume lines

Blue Rocker covers

NGK Iridium Plugs, less than 10 000kms old.

New Oil Catch Can

Apexi RSM-G (Rev Speed Meter with G-Sensor, for power calculation, and 1/4 mile times, plus a heap more!)

Nismo Clear side indicators

12" Sony X-Plod Sub

1200w Boch Mann Amp

6' MTX splits in the front

Pioneer USB/Aux in headunit

Boot has been recoloured in Blue

Has had custom painting on the side skirts and front and rear bumpers

AutoMeter Boost Gauge

AutoMeter Air/Fuel Gauge

Apexi Turbo Timer/voltage display/air fuel display.

Runs 10psi, never been run over that, but is capable of it!

All interier is in almost new condition, rear seats never used, and front seats always covered

Custom Plates, black on white CME-33.

17" Precedo Racing Rims

New Federal SuperSteel 225 Width tyres on the back

New Firenza ST-03 225 width Tyres on the front

Tein Damper adjustable Coilovers

Also:

4 x 16" Origional Skyline rims in black, all with good tyres

4 x 16" Tyres, 2 almost new, 2 ok

4 x 17" Falcon rims in black, all with tyres, 2 may need replacing to be used on road (pictured)

Front Spoiler Chin, is damaged by scraping

post-54349-1234173130_thumb.jpg

Edited by R33_GTST1111
Link to comment
https://www.sau.com.au/forums/topic/256295-r33-gtst-for-sale/
Share on other sites

  • 2 weeks later...


  • Similar Content

  • Latest Posts

    • Order for the 2025 model R35 GT-R were accepted from 3rd March and 26th August the last order rolled off the production line at the Tochigi plant. Concerning the R35 GT-R replacement, current Nissan CEO Ivan Espinosa said "Nothing has been decided about the GT-R at this time, but we are well aware that everyone is waiting. The GT-R will evolve and reappear in the future. Please be patient until that day comes." Nissan has a lot of issues with management and finances so take Espinosa's words with a big grain of salt. From what discussions I've had and read about here in Japan, not a lot of people are confident about Nissan's future, let alone the next GT-R. 
    • Thanks. We getting some parts along too so he will be solving the speed issue like next week so i will let you know what he came up with.   
    • 21 is explicitly the coils detected as the issue. Is it guaranteed the actual issue? No. Just the ECU thinks it is. When you say rattling, describe it better, get an audio clip as best you can if possible.
    • Yea got me coppers. Bad news is I just put them in and the car still has the light and shakes. I also noticed I hear like rattling coming from the exhaust piping right under me. Does 21 also have a possibility of being O2 sensors?   So, coil packs are good, the harness is good, the MAF is working, and obviously the spark plugs just replaced and working.
    • Make sure you drop the GTT base tune back in, and set your injectors again, this will remove anything playing up with it you may have removed. Possibly lean there as it's normally a fast transient going THROUGH atmospheric pressure, and a turbo motor would then quickly go richer as boost builds. The only worry you MIGHT have is ignition timing, as the DE is higher compression than the DET from memory. But again, you're not in boost, so the DE motor will be a lot more forgiving at atmospheric.   Get Murray, Kinkstahs, and Johnny's input on tuning haltechs, those guys have played with tuning enough in the past to be able to help now you're past the trouble shooting stage of the MAP issue
×
×
  • Create New...