Jump to content
SAU Community

Recommended Posts

err hey.

so i got my skyline 2 weeks ago. ive since done a oil change (motul 300v) oil filter change, and replaced plugs (iridiums) as there was a missfire problem.

so on way home today, i gave it a bit of heavy foot to overtake this truck before traffic in the right got to close for me to move over.

after i overtook him and slowed down i could smell fuel..

my friend thinks its running rich?

any help much appreciated :ermm:

Link to comment
https://www.sau.com.au/forums/topic/258777-fuel-issue-closed/
Share on other sites

yeh stock ecu.

ive got intercooler, back end of exhaust, splitfire coil packs, iridium plugs,red stuff break pads, remote start n thats it as far as i know

o and bilstein shocks

mm running rich, yeh thats wat my mate said. he also said itl lean out once i get full exhaust.

another problem found today.. only jus put those red stuff pads in , 100k's ago. was hearing squealing sound before i changed.. 50k's after change, started hearing it a tiny bit when breaking to stop at lights.

and within the last 20k's its been getting worse.

what is wrong now?

mm running rich, yeh thats wat my mate said. he also said itl lean out once i get full exhaust.

I doubt it's going to lean out by doing more mods mate, you'll need to buy an SAFC or aftermarket ECU to let you adjust the fuel, otherwise just live with it. The stock ECU will add extra fule to make everything safe.

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...