Jump to content
SAU Community

Firewall/grommet

g33k

By g33k,
in V Series (V35, V36, V37 & Infiniti)

 Share

Recommended Posts

g33k Community Regular

g33k

Posted
Posted

Hi Guys,

The installation of my CarPuter has begun. I have begun mounting the monitor in the cubby.

After popping the hood, i found two grommets which i "think" go through the firewall.

One in front of the drivers seat, top left (if your in front of the hood) - which looks a little tricky.

The other, right hand side, top corner which looks like it would feed somewhere around the glove box?

Does anyone know what the easiest way to get a positive wire inside is? - Does the right grommet pop off?

I'd prefer not to drill....

Appreciate the help =)

Speak soon!

Link to comment
https://www.sau.com.au/forums/topic/259039-firewallgrommet/
Share on other sites
Chris Rogers Grand Master

Chris Rogers

Posted
Posted

remove EVERYTHING around the passnegner grommet and untape it. getting a 4awg cable through it neatly is a bitch but can be done.

that ENTIRE corner has to come out/apart and most of the stuff arcoss the top as well.

stagea is the same and I've done that one in a similar fashion.

Link to comment
https://www.sau.com.au/forums/topic/259039-firewallgrommet/#findComment-4451442
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • Julsmadrid
      RB25 Drama's

      By Julsmadrid · Posted

      Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • oxisau
      Jacks that fit under GTR lips that can reach the subframe?

      By oxisau · Posted

      I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • nash47
      Cas issue

      By nash47 · Posted

      No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • shubby0901
      Living With An R33 Gtst

      By shubby0901 · Posted

      Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
    • GTSBoy
      R34 - Switching cluster from non turbo auto --> turbo manual after diff change

      By GTSBoy · Posted

      I guess. The diff and the speedo are gearbox agnostic.
×
×
  • Create New...