Jump to content
SAU Community

mainly HR31 bits

rason juse
 Share

Recommended Posts

rason juse Rookie

rason juse

Posted
Posted

Hi guys gotta clear some space & refurbish the funds for the project so I have the following up for sale,

RB20 12 port head with ECCS manifold $300.00

HR31 GTS/X rear axles 150.00

RB30 extractors off VL I think will fit R31 80.00

HR31 GTS/X entire rear end with R200 450.00

RB30 head with manifold r/c & dizzy 200.00

RB20 r/c & coil cover (red) 50.00

HR31 reconditioned hicus p/s pump 250.00

HR31 GTS/X boot lid with spoiler g/c 300.00

HR31 GTS/X drivers door (small dent) 200.00

HR31 GTS/X carpet black g/c 100.00

HR31 GTS/X rear seat g/c 200.00

910 series import bluebird entire rear end with R180 open center diff & Koni adjustables (imports had I.R.S.) 350.00

Z18 turbo head 200.00

Thats all for the moment folks until I sort through some more stuff, I'm located on the Gold Coast & I'm contactable as follows,

(07) 5537 1515w

(07) 5502 1996h

[email protected]

or reply here,

Thanx

Link to comment
https://www.sau.com.au/forums/topic/26102-mainly-hr31-bits/
Share on other sites
  • 1 month later...
  • 2 years later...
  • 3 years later...
Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Dose Pipe Sutututu
      What brakes on R34 GTT(Europe)

      By Dose Pipe Sutututu · Posted

      Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • soviet_merlin
      WGNC34 - floor mats

      By soviet_merlin · Posted

      Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • joshuaho96
      Tomei gasket

      By joshuaho96 · Posted

      I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • GTSBoy
      What brakes on R34 GTT(Europe)

      By GTSBoy · Posted

      The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Kapr
      What brakes on R34 GTT(Europe)

      By Kapr · Posted

      Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...