Jump to content
SAU Community

Inner West Crew Whoretown (toowong/st Lucia/kenmore/indooroopilly And Sometimes Sunnybank?)


Recommended Posts

Say Hi to your mum for me.

and tell her that her bra is in the back of my 180, and ask if she could post my jocks, i think they are still in her room..

and tell her that her bra is in the back of my 180, and ask if she could post my jocks, i think they are still in her room..

Virtual Hi 5!! Is needed.

post-18611-1254705740_thumb.png

status on your car bro?

dave explained it to be briefly..

whats the go atm?

Massvie cam lash, which is throwing errors into the ecu and thus turning the car off. When I had the water pump done, the cam belt was done up so tight, I was lucky it didn't snap and throw valves into the motor, so thanks to the muppet who did that, its created the chain of events. It just one of those things that this problem and the fuel pump problem happened at the same time

ugh thats shit mang :P

so now shes at the workshop getting sorted out?

1j it? ;)

Yeap ERD is onto it.

Replacing belt, putting new belt bearing's, replacing temp sensor so the ecu reads right water temp so stop those error's too, CAS might be dicky so bought one from dave as a tester.

Should be back in a week or so running even better than what it did

did you steal time away from my GTR Josh?? cause I would like to drive it again one day :P

haha i told dan to take his time, as it's my only car i wana make sure it wont stop in traffic

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Hi. This is just my curiosity because iam sure the tuner figure something out...but either way i want to ask. The "problem" is that the Nistune ECU (Stagea FW and RB25DET NEO from Stagea) sees many times the speed than the speedo does(he says the speedo show 120 km/h - correct speed and the ECU shows like 510km/h ) I told him that this car/tranny getting speed from rear diff. If iam not mistaken the RB25DET NEO "need" to see tranny speed sensor? (my tranny has the plug for it). So couple of "question" If he connects/wire the speed sensor to the tranny...are the signals gonna intervene and if...what if he disconnects the rear diff one and the speedo stops working? Or the "new" sensor from the tranny "take over" and will not going need the one from diff? As i said i know he figure/get that done...iam just curious to know what are the solutions 🙂 
    • Your IACV is set to idle too low. You need to adjust it via the screw Duncan mentioned. From memory it should be 650rpm with the valve electrics unplugged. What is it trying to idle at with the IACV plugged in?
    • Ahhh, I need the whole head unit. I definitely needed to roll back through and review your setup, ha ha! Neat setup they have going on. I just need a full double din head unit. But I want good and responsive. I might have to review what the likes of pioneer have out these days.
    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
×
×
  • Create New...