Jump to content
SAU Community

Inner West Crew Whoretown (toowong/st Lucia/kenmore/indooroopilly And Sometimes Sunnybank?)


Recommended Posts

multistud

colin buy buy buy! go 9s but :)

bought gone 8s front 9s rear though. 205/40/17s on the front and 215/40/17 on the rears

bought gone 8s front 9s rear though. 205/40/17s on the front and 215/40/17 on the rears

What's this for? Your 31? Cause you must be more camp then a row of tents, if you are going to run them over what you have on your 32.

What's this for? Your 31? Cause you must be more camp then a row of tents, if you are going to run them over what you have on your 32.

haha yeah its for the 31. 1 of the works cost the same as the set of these ones :)

colin im epic impressed :D

and you'll be impressed by my epic reading :P

and ill be impressed by your epic football tonight - provided you dont play like the english defenders :P

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Was that with the cas upside or correct way up?
    • Did and sync timing with light 
    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
×
×
  • Create New...