Rb25/30 Engine Package, Requires Machining & Assembly

[Shano3000]

Parts include:

Rb25de non vct head from a R32. Head has been cleaned, new valve stem seals, heavy duty springs for turbo application and surface machined flat.

Inlet manifold, injectors and fuel rail, Coil packs, throttle body and all bolts/miscelanious pipes etc.

Series 2 RB30 block, requires maching bore/hone etc. Crankshaft also requires machining. Standard rods & all bolts required for assembly.

Good Condition S2 RB30 Bottom End, fully assembled. Brought as working motor and stripped head etc off

New ACL cast RB30 pistons, rings and bearings. Pistons are 1mm oversize and bearings .25mm oversize.

RB30 complete engine gasket kit with Headgasket.

Pistons are for a RB30 non turbo, so when assembled with RB25DE head will give compression ratio of around 8.3-1

As stated the block will need to be bored 1mm oversize to accomodate the pistons and the crankshaft ground .25mm for the bearings. This is a complete package and once assembled will handle up to 350rwkw. Was planning to assemble this engine and put in my R32 although being a full time student i just dont have the cash.

Price $1000 for the lot. Contact through PM or call on 0422816780.

Pictures : http://s160.photobucket.com/albums/t177/Shano3000/

[r32_gts-t]

hey mate where about are you located

[Shano3000]

Located in SE Melbourne. As it says in my details.

[r32_gts-t]

oh ok spewin wish you were located in adelaide

[Shano3000]

$200 to get a pellet with everything on it delivered to Adelaide if interested.

[r32_gts-t]

how much for the head if keen to seperate

[Shano3000]

$650 delivered to your door firm. Cheers, Shane