Jump to content
SAU Community

Recommended Posts

i have a 33 GTR and was driving today , and started to get a funny smell in the car now and then ...... after a while i could see vapour coming from the rear parcel shelf i pulled over and

opened the boot i could hear the battery hissing ! and it was HOT i mean REALLY HOT i couldnt touch it it was that hot . i disconnected the negative terminal and drove home . took the battery out and its

still extremely hot 2 hours later like its generating its own heat ????

im thinking its either the battery has collapsed inside or the alternator is over charging it ..... where is alternator fuse?

anybody got any ideas ?

(i put battery out of another car into the 33 and am going to give it a run )

oh yeah i have an aftermarket steering wheel which i removed and put back on and now the airbag light wont stop flashing (i clipped yellow box back into airbag wires) not sure if this is all related

I had a similar issue with a Exide Orbital blue top. Basically I came to this conclusion - battery had been deepcycled a few times (fine as the blutop is a dedicated deepcycle battery), but after each deep cycle it should have a good high voltage/ high amp charge, the factory system/alternator cannot provide this. It still charges the battery, but performance/capacity is lost. A hand full of deep cycles evenuated in my battery just getting rather damn hot and not holding a charge. A friend bought a Projecta digital charger that has a high amp and voltage charging setting (with 7 stage charging) and also a battery "reconditioner" mode for batteries that are fairly poked. Basicallly it should be able recondition nearly poked batteries, mine was too far gone so I had to buy a new one, hard eggs to swallow when I bought mine new only few years ago and they are now around 5spot over here in NZ. My local battery guy also said I was lucky not to cook the alternator.

By yellow hat dry cell, do you mean it is an Optima or similar battery? The battery will hold heat for a long time as it will have lead based plates and if gel cell they will be sandwhiched in spirals and basically retain heat well.

Sounds like it's poked, have you had issues of the battery not holding the charge for long? i.e. don't drive it for a couple days and it won't start?

So, get it onto a good charger like the one mentioned above (http://www.projecta.com.au/catalogue/cid/54/asset_id/153/). Otherwise, buy a new one, yours sounds well and truely cooked. Make sure it is charged correctly after any major drains in the future. I'll be sticking mine on the Projecta every 6 months or after any deep cycles from now on.

Hope this helps.

I had a similar issue with a Exide Orbital blue top. Basically I came to this conclusion - battery had been deepcycled a few times (fine as the blutop is a dedicated deepcycle battery), but after each deep cycle it should have a good high voltage/ high amp charge, the factory system/alternator cannot provide this. It still charges the battery, but performance/capacity is lost. A hand full of deep cycles evenuated in my battery just getting rather damn hot and not holding a charge. A friend bought a Projecta digital charger that has a high amp and voltage charging setting (with 7 stage charging) and also a battery "reconditioner" mode for batteries that are fairly poked. Basicallly it should be able recondition nearly poked batteries, mine was too far gone so I had to buy a new one, hard eggs to swallow when I bought mine new only few years ago and they are now around 5spot over here in NZ. My local battery guy also said I was lucky not to cook the alternator.

By yellow hat dry cell, do you mean it is an Optima or similar battery? The battery will hold heat for a long time as it will have lead based plates and if gel cell they will be sandwhiched in spirals and basically retain heat well.

Sounds like it's poked, have you had issues of the battery not holding the charge for long? i.e. don't drive it for a couple days and it won't start?

So, get it onto a good charger like the one mentioned above (http://www.projecta.com.au/catalogue/cid/54/asset_id/153/). Otherwise, buy a new one, yours sounds well and truely cooked. Make sure it is charged correctly after any major drains in the future. I'll be sticking mine on the Projecta every 6 months or after any deep cycles from now on.

Hope this helps.

battery is optima yellow hat.

the car had been sitting for a few months so battery was dead flat , i jump started it from the front of the car with a red optima and some jumper cables drove it all day seem to charge it up.

next day while driving around was when i smelt the battery. (car has 500hp )

the engine has only done 15000 kms so im assuming alternator is fine

battery is optima yellow hat.

the car had been sitting for a few months so battery was dead flat , i jump started it from the front of the car with a red optima and some jumper cables drove it all day seem to charge it up.

next day while driving around was when i smelt the battery. (car has 500hp )

the engine has only done 15000 kms so im assuming alternator is fine

As I said, get it on to a good charger like this one - http://www.projecta.com.au/catalogue/cid/54/asset_id/153/ - it may be salvagable, otherwise, if you keep using your alternator to charge it, it will die (if it hasn't already). The Optimas handle deep cycling(full discharge/flat) well, but you do have to charge them up properly when they run below 11 volts in my experience.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I got back to Japan in January and was keen to get back on track as quickly as possible. Europe is god-awful for track accessibility (by comparison), so I picked up a first-gen GT86 in December just to have something I could jump into right away. The Skyline came over in a container this time and landed in early January. It was a bit battered after Europe, though—I refused to do anything beyond essential upkeep while it was over there. The clutch master cylinder gave out, and so did the power steering. I didn’t even bother changing the oil; it was the same stuff that went in just before I left Japan the first time. Naughty. Power steering parts would’ve cost double with shipping and taxes, so knowing I’d be heading back to Japan, I just postponed it and powered through the arm workout. It took a solid three months to get the car back on the road. Registration was a nightmare this time around. There were a bunch of BS fees to navigate, and sourcing parts was a headache. I needed stock seats for shaken, mistakenly blew 34k JPY on some ENR34 seats—which, of course, didn’t fit—then ended up having the car’s technical sheet amended to register it as a two-seater with the Brides. Then there’s the GT86. Amazing car. Does everything I want it to do. Parts are cheap, easy to find, and I don’t care what anyone says—it’s super rewarding to drive. I’ve done a few basic mods: diff ratio, coilovers, discs, pads, seat, etc. It already had a new exhaust manifold and the 180kph limiter removed, so I assume it’s running some kind of map. I’ve just been thrashing it at the track non-stop—mostly Fuji Speedway now, since I need something with higher speed after all that autobahn time. The wheels on the R34 always pissed me off—too big, and it was a nightmare getting tires to fit properly under the arches. So I threw in the towel and bought something that fits better. Looks way cleaner too (at least to me)—less hotboy, less attention-seeking. Still an R34, though. Now for future plans. There are a few things still outstanding with the car. First up, the rear subframe needs an overhaul—that’s priority one. Next, I need to figure out an engine rebuild plan. No timeline yet, but I want to keep it economical—not cutting corners, just not throwing tens of thousands at a mechanic I can barely communicate with. And finally, paint. Plus a bit of tidying up here and there.  
    • Nope, needed to clearance under the bar a little with a heat gun, a 1/2" extension as the "clearancer", and big hammer, I was aware of this from the onset, they fit a 2.0 with this intake no problems, but, the 2.5 is around 15mm taller than a 2.0, so "clearancing" was required  It "just" touched when test fitting, now, I have about 10mm of clearance  You cannot see where it was done, and so far, there's no contact when giving it the beans Happy days
    • It's been a while since I've updated this thread. The last year (and some) has been very hectic. In the second-half of 2024 I took the R34 on a trip through Germany, Italy, France and Switzerland - it was f*cking great. I got a little annoyed with the attention the car was getting around Europe and really didn't drive it that much. I could barely work on the car since I was living in an inner-city apartment (with underground parking). During the trip, the car lost power steering in France - split hose - and I ended up driving around 4,000kms with no power steering.  There were a few Nurburgring trips here and there, but in total the R34 amassed just shy of 7,000kms on European roads. Long story short, I broke up with the reason I was transferred to Europe for and requested to be moved back to Japan. The E90, loved it. It was a sunk cost of around EUR 10,000 and I sold it to a friend for EUR 1,500 just to get rid of it quickly. Trust me, moving countries f*cking sucks and I could not be bothered to be as methodical as I was the first time around.
    • I assume clearances were all a-okay?
×
×
  • Create New...