Jump to content
SAU Community

Recommended Posts

Hey guys, got a speeding fine the other day, for going 108 down princes freeway (Melbourne bound) near Werribee on a Monday at 10:47 am. Now I immediately know this wasnt me as a I barely go to Melbourne (live in Geelong). I know my girlfriend goes to Melbourne and she takes my car on Mondays, however she is in a uni class all monday morning, she drives down at 2. I know it says aprox. time but is 3 hours off approximate? To my knowledge the car wasnt stolen and returned or anything, but should i question it?? We are both on P's so i dont really want either of us to loose a point.

Thanks - Burgies

Link to comment
https://www.sau.com.au/forums/topic/267325-quick-question/
Share on other sites

Just call Civic Compliance up and tell them that you, nor the girlfriend wasnt anywhere near that vicinity at that time stated. They can bring up photos and just make them double check it.

Worst comes to worst, you're going to have to go down to civic compliance and ask to see the picture in person.

Link to comment
https://www.sau.com.au/forums/topic/267325-quick-question/#findComment-4559799
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • My thought is if you were just moving it forward and the upstream geometry remained the same, then no difference at all. But because the current one has the filter direct into the AFM inlet, you effectively have the best chance of a completely symmetric air flow profile upstream, and in, the AFM, whilst the aftermarket inlet thingo has a (small, to be sure) bend between the filter and the AFM. That would bias the flow to the outside of the bend (downstream of the bend) which might well reduce the size of the signal seen by the AFM, for the same total flow rate. Having said that: If you're proposing to make your inlet look like a hybrid of your existing one and the aftermarket one, such that there is no bend where the filter is clamped on... then I say it will be just fine. If there is going to be such a bend, then, if you can align the insertion of the AFM blade such that it is at right angles to the plane of the bend, then there is a better than even chance that the centreline velocity where the blade is will remain more or less the same, and the velocity will just be a little faster to the outside of that, and just a little slower to the inside. **This is not professional investment advice and you should consult a suitably qualified ouija board, tea leaves or the intestines of a goat for more accurate prognostication.
    • Hi Tao, Thanks for your reply.  It's been a while and I managed to get the valve stem seals replaced with the head on the car.  Unfortunately this didn't solve my issue, the car still smokes a lot after idling (to be honest during idle you can see a bit of blue smoke from the exhaust), same after deceleration. I will try disconnecting the valve cover breathers, do I leave the PCV valve in? By engine oil drain pipe, do you mean the turbo oil drain?
    • What about if you just give it direct 12v and earth?
    • Hi guys . Can someone help me  I bought an Android screen for my Nissan fuga but it won't turn on   
    • My guesstimate, with no real numbers to back it up, is it won't effect it greatly at all.its not a huge change in position, and I can't see the air flow changing from in turbulence that much based on distance, and what's in front of it. Johnny and Brad may have some more numbers to share from experience though.
×
×
  • Create New...