Where To Buy Brand New Loom Plugs For Rb26 Wiring Loom?

[CameronBNR32]

Doing a new loom for my race car and a few of the plugs are old/cracked/shit, trying to find a place to get as many as I can.

I am mainly after crank angle sensor plug, coil pack loom plug, sard injector plugs, air temp and water temp plugs.

I've tried Automotive Service Solutions / Petroject, Motec, Repco, Autobarn, and a few auto electricians but to no avail.

any one know of a place that sells these? would rather not buy a whole new loom from Nissan as I would then just hack it up.

thanks

[R31Nismoid]

Nissan means you have to buy the loom as you know

Otherwise, one option is to find someone selling a 2nd hand loom with some decent connectors...

I might just happen to have one next week by chance

Even then your still looking @ a few hundred

Other option is to get some generic plugs and rewire each connector and so on.

[Swiper the Fox]

i use deutsch connectors...the best.

http://www.deutsch.net/deutsch-product-search.aspx?page=3

[The Dan]

Doing a new loom for my race car and a few of the plugs are old/cracked/shit, trying to find a place to get as many as I can.

I am mainly after crank angle sensor plug, coil pack loom plug, sard injector plugs, air temp and water temp plugs.

I've tried Automotive Service Solutions / Petroject, Motec, Repco, Autobarn, and a few auto electricians but to no avail.

any one know of a place that sells these? would rather not buy a whole new loom from Nissan as I would then just hack it up.

thanks

If it's the oval SARD injector plug...N16 pulsar, toyota Yaris, plus most of the new 4 cyl range out there. Just drop into your local wreckers.

The coolant temp sensor I think can take the same plug as the oval SARD but you have to scrape off the guides on the side of the sensor. Check before you scrape though.

Crank angle sensor is a little more difficult. I would say as advised above, get one from a good loom.

[CameronBNR32]

cheers guys.

I have been able to find a few new plugs , c.a.s, throttle position cable and all the injector plugs, I will probably still need to get is water and air temp and the coil pack loom male plug and I should be set.