Jump to content
SAU Community

Recommended Posts

I thaught i would re-advertise as a bit has changed.

1997 Stagea with ALL Autech 260RS S2 running gear, interior etc,

Motor was rebuilt approx 7000km's ago by Gavin wood Autotech, all parts mods etc 7000km's old.

167000km's on the chassis.

Excellent condition through out, beautifull car to drive, has the power and handling and is also happy to putt around. I use this as my daily with my 2 kids, awesome daily, unfortunatley its just not big enough, killing me to sell it, i got it built up as how i wanted it.

Details:

RB26DETT

Arias pistons

Eagle rods

ACL race series bearings

Fully balanced everything (crank, rods, flywheel, clutch etc)

Crank work (crack tested linished etc)

Block work (acid dipped, decked, crack tested)

N1 pumps

Tomie oil restrictor

Tomei sump baffel

Trust MHG

Trust 264deg cam's

All new genuine gaskets through out

New timing gear throughout

Head fully recon'd (lifters set for cams, guides etc)

New engine mounts, Gbox mounts etc

Platinum plugs

2 x Garret GT2860-7's

Apexi PFC (no hand controller)

Turbotech bleed valve

HKS pods

HKS tuned length front pipe

HKS catback

Stock dumps and GTR cat

New belts

Cleaned stock injectors

Walbro in tank 600hp pump can be supplied

ISC 52mm alloy rad (not fitted in pics)

Driveline:

New excedy cerametalic single plate clutch (rated to 330rwkw)

All 260RS driveline: mech diff, autech cradle etc

All new oils etc

Brakes:

New Master cylinder

Factory Autech 260RS brembo's

New Project Mu B spec pads

New rotors all round

New brake fluid

Suspension:

Nismo struts

Hicas breaker bar

New sway bar link bushes rear

New sway bar mount bushes front and rear

Exterior:

All factory Autech 260RS bodykit

Factory Autech rims with Kuhmo ecsta sport KU31's (3000km's old)

Fully tinted

new windscreen

Factory HID's

Interior:

Full autech interior

Trust turbo timer

Clarion CD player (dosnt work that well)

Alarm and central locking

Air con just regassed with new reciever drier

factory privacy blind and net

Auotmeter boost gauge in Mearcat pod

Car made 304ahwhp @ a little under 10psi. Limited by the stock fuel pump (hence the new walbro). Car was tuned at X-speed. They said with the combo on the car with the new pump, EBC and bigger injector you should see 450-460awhp @ 20psi ish, safley reliably, easily and responsively.

I have a HEAP of spares that can go with it.

I am chasing $33,000 ono

I will consider trade's/swaps for a 4x4 ute or wagon of lesser or equal value with cash etc or something S1X or R3X and the cash difference my way etc.

Im located in Bunbury WA.

0419943997

sorry for the crappy pics will try and get some better ones when its clean.

DSC04134.jpg

DSC04132.jpg

DSC04136.jpg

DSC04137.jpg

DSC04129.jpg

DSC04131.jpg

Link to comment
https://www.sau.com.au/forums/topic/273869-autech-260rs-replica/
Share on other sites

This price is high as all hell. My mate just sold his genuine Autech with 550awhp for 27k.... Good luck getting anywhere near this price.

Thanks for the totally helpfull post mate. Much appreciated.

If this is Kens stagea your talking about im fully aware of that.

Thanks.

Will pay transport costs for any non WA buyer.

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Also, I logged some data from the ECU for each session (mostly oil pressures and various temps, but also speed, revs etc, can't believe I forgot accelerator position). The Ecutek data loads nicely to datazap, I got good data from sessions 2, 3 and 4: https://datazap.me/u/duncanhandleyhgeconsultingcomau/250813-wakefield-session-2?log=0&data=7 https://datazap.me/u/duncanhandleyhgeconsultingcomau/250813-wakefield-session-3?log=0&data=6 https://datazap.me/u/duncanhandleyhgeconsultingcomau/250813-wakefield-session-4?log=0&data=6 Each session is cut into 3 files but loaded together, you can change between them in the top left. As the test sessions are mostly about the car, not me, I basically start by checking the oil pressure (good, or at least consistent all day). These have an electrically controlled oil pump which targets 25psi(!) at low load and 50 at high. I'm running a much thicker oil than recommended by nissan (they said 0w20, I'm running 10w40) so its a little higher. The main thing is that it doesn't drop too far, eg in the long left hand fish hook, or under brakes so I know I'm not getting oil surge. Good start. Then Oil and Coolant temp, plus intercooler and intake temps, like this: Keeping in mind ambient was about 5o at session 2, I'd say the oil temp is good. The coolant temp as OK but a big worry for hot days (it was getting to 110 back in Feb when it was 35o) so I need to keep addressing that. The water to air intercooler is working totally backwards where we get 5o air in the intake, squish/warm it in the turbos (unknown temp) then run it through the intercoolers which are say 65o max in this case, then the result is 20o air into the engine......the day was too atypical to draw a conclusion on that I think, in the united states of freedom they do a lot of upsizing the intercooler and heat exchanger cores to get those temps down but they were OK this time. The other interesting (but not concerning) part for me was the turbo speed vs boost graph: I circled an example from the main straight. With the tune boost peaks at around 18psi but it deliberately drops to about 14psi at redline because the turbos are tiny - they choke at high revs and just create more heat than power if you run them hard all the way. But you can also see the turbo speed at the same time; it raises from about 180,000rpm to 210,000rpm which the boost falls....imagine the turbine speed if they held 18psi to redline. The wastegates are electrically controlled so there is a heap of logic about boost target, actual boost, delta etc etc but it all seems to work well
    • hahah when youtube subscribers are faster than my updates here. Yes some vid from the day is up, here:  Note that as with all track day videos it is boring watching after the bloopers at the start.  The off was a genuine surprise to me, I've literally done a thousand laps around the place and I've never had instability there; basically it rolled into oversteer, slipped, gripped and spat me out. On the way off I mowed down one of the instructor's cones and it sat there all day looking at me with accusing cone eyes as I drove past. 1:13:20 was my fastest lap, and it was in the second session, 3rd lap.  It (or me!) got slower throughout the day as it got hotter.      
    • It sounds like you want what the Toyota Landcruisers have for their roof racks. Wanna know what you end up with? Rust holes in the roof, and water everywhere...
    • Discovered today that if I select reverse first and take my foot off the brake, then select drive, the drive indicator light works and so does the tiptronic gear indicator. 
    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is maybe 1 wire in the ecu plug I need to move to rectify this. Does anyone here have any ideas?   Cheers guys
×
×
  • Create New...