Jump to content
SAU Community

Recommended Posts

Work Emotion Xd9 18x9+20 (215/40/18) 18x10+18 (235/40/18)

Putting my Work's up for sale. I can guarantee you that you will get pussy if you put these wheels on your car and if you don't, you should be giving up on pussy all together. So if you want to be super cool on Nissansilvia.com and think your JDM as F*ck then BUY BUY BUY

Would fit perfect on an R33/R34 will need a flare on a R32. Fronts have a few marks on the rim from the old owner who apparently dropped them when fitting tires. Tires on the front are Dunlop Direnza with 85% tread (mark on one from guard rubbing on tire from old owner) and the rears are brand new still in the box and I've just got some Kuhmo KU31 tires in for them yesterday, I haven't fitted them yet but I can if need be.

In all honesty I just want back what I've paid for the wheels, so basically your getting free tires with them. Don't want any low ball bullshit offers nor do I want to hear that I'm selling them for too much, you'll be hard pressed to get these wheels in with the same tires for the price I'm asking. Fronts were on my car for two days then I got defected so they came off. If you want some quality dished jap rims for your car these are what you need.

$3,000 - Wheels will be shipped at buyers expense.

P1000706.jpg

P1000710.jpg

P1000712.jpg

P1000707.jpg

Link to comment
https://www.sau.com.au/forums/topic/277835-work-emotion-xd9-white/
Share on other sites

  • 1 month later...

No idea how your paying 350each when even the work site labels them at 62000yen each, as seen here http://www.work-wheels.co.jp/catalog/pdf/45.pdf

:devil: dreamers

You're probably looking at about $2,700-$2,900 del for 18" XD9's in white with the exchange rate and that is buying straight from work. Factor in the the tires which the fronts came with the Dunlops on them and the brand new rear tires PLUS work nuts.

If you can get XD9's delivered here for $1,500 like you said.. why are you posting in my thread?

$3,000 O.N.O simple. You don't want them or you think you can get them cheaper. By all means give it a shot.

Edited by J-Dawg
  • 2 weeks later...
  • 2 weeks later...

nice wheels man! i'm looking at a set of gunmetal ruffly same spec as those if not then the 17's, how'd the go under your gaurds? (ie: what work did you do)

oops just read your 2nd paragraph

Edited by BstewyR33

I had the same sizes just different wheels before hand and they sat pretty good on the rear with it sitting real low. Fronts would need abit of guard work. But for a R33 it would sit flush all the way around

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...