Jump to content
SAU Community

Recommended Posts

Heya doods,recently installed a coupe tail light conversion on my 4dr gtst and have hit a wall.

Im wondering if a coupe boot lid wud fit as i know it takes alot of custom nip tukking to get the ol 4dr boot lid to fit.

As i am one for easy ways out if the coupe lid will fit ill be all for it.

Any help will be much appreciated!!!!!!!!! as google aint helping me at all :)

Link to comment
https://www.sau.com.au/forums/topic/281810-coupe-tail-light-conversion/
Share on other sites

  • 2 weeks later...

hey mate, talking about a 32?

i tried to convert 2 door 2 4 door tail lights and its completely diffrent.

1. boot lids are diffrent size

2. 2 door lights would easily fit 4 door however this wont match with boot / rear bar

3. rear bar is diffrent.

main reason it wont work is the 2 door has more rounded set lights whereas 4 door more square. and not to mention boot lid is diffrent size.

However, given this i have seen a photo of a 4 door with coupe rear end.

Would you have any idea where i can find this photo??

Ive modified the rear end to suit the tailights and have fitted them into the back with the rear bar as well just need to find a way to get the boot to fit.

btw i have a four door boot lid and a coupe so either option is avail.

I rekon i could cut the coupe bootlid down to size but dont know if the curve of the that goes down the rear of the car is the same as the four door boot.So dunno whether it will line up with tailights.

Just wondering...why u want four door tailights on the coupe??

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I'm with you here. It's either loom has an issue, OR, injectors are not functioning properly. It could even be they're just constantly dribbling, hence the wet, but not firing.
    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
×
×
  • Create New...