Jump to content
SAU Community

Recommended Posts

Mods:

- Clear Nismo indicators

- Splitfire Coil Packs

- Nismo 600cc injectors

- Greddy turbo timer

- Blitz dual solenoid Boost Controller

- Apexi PFC + Hand controller

- Exhaust noise controll valve

- Blitz pannel air filter "washable"

- Tomie Adjustable Cam gears.

- Xforce front pipe and high flow cat 3"

- Nismo cat back exhaust

- Volk Rays Racing rims 18x10"

- Ogura twin plate clutch

Always garaged and replaced with 100% Full Synthetic Oil in every 4000-5000 Kms.

I'm the first owner since it arrived in Aust. almost 4 years ago (In stock form). After a while it was fine tune by professional mechanic . Very conservative power but very reponsive and fun to drive every day. Maximum boost (1.0bar) kicks in only at around 3200rpm).

Contact: Brandon 0413459016 Maribyrnong, Victoria.

post-30200-1257769800_thumb.jpg

post-30200-1257769810_thumb.jpg

post-30200-1257769821_thumb.jpg

post-30200-1257769832_thumb.jpg

post-30200-1257769844_thumb.jpg

post-30200-1257769855_thumb.jpg

post-30200-1257769866_thumb.jpg

post-30200-1257769875_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/295597-r34-gtr-vspec-1999-bayside-blue/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...