Jump to content
SAU Community

Fs: Gt30 3071r Turbo Complete Package Rb25det

Robo's
 Share

Recommended Posts

Robo's Mentor

Robo's

Posted
Posted

I am selling my complete turbo kit suit R33 25DET producing 280rwkw on high boost and 245rwkw on low boost.

This was produced on a relative conservative dyno. I never ran it down the 1/4, but going by my old times (12.1@116mph from

a HKS2535), this would easily run a high 11 at 120mph.

Kit includes everything to bolt on:

Kit includes

Turbo 3071r internal wastegate

custom dump pipe to catalytic convertor. This has a split wastegate design.

Silicon rubber 4 inch intake to your AFM.

Comes with water and oil line connectors.

This is a great street turbo. Boost comes on very early producing full boost by 3500rpm on a standard RB25 motor.

With boost coming on early, mid-range power is very strong.

Turbo is currently on the car so if anyone in Melbourne is keen, i could show them it running.

$1,500 Delivered anywhere in Australia

0402910486 Darren

post-14092-1260698923_thumb.jpg

post-14092-1260698965_thumb.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Kinkstaah
      NC MX5

      By Kinkstaah · Posted

      I am well aware as I did rant at him to buy a MX5, buy the 2.5 before he DIY'ed it, etc as well as do things to the holden. He will obtain a ND. It's the best of both worlds. They look great in person, definitely the best looking one. Just a matter of time now.
    • r32-25t
      NC MX5

      By r32-25t · Posted

      Remember this is the same person who said he’d never own an nc 
    • zique
      Ceramic turbine damage to engine - what did yours do?

      By zique · Posted

      ouch! how is the car now?I had sold my gtr but have been looking into some on trademe and a 260RS but I wouldnt be keen on any repairs needed on them
    • MBS206
      NC MX5

      By MBS206 · Posted

      This sounds like someone who would have owned an R33 in their past... It's okay, I'm 100% picking up what you're putting down Mark.
    • MBS206
      Jacks that fit under GTR lips that can reach the subframe?

      By MBS206 · Posted

      Just back on what was raised about jacking off the the tow/tie down point on the front of cars. I've used it plenty. I've also watched it on a car where you could see it move the front end of the car. It was like the front end/whole car being tweaked and twisted a bit. I will say, I struggle to find good jacking points on MOST cars. The ones that have good points, I then normally struggle to find a jack tall enough to make the car change height!   One of my go to points for either the jack, or the axel stands though, is either a suspension pickup point, OR a subframe to chassis major bolting point. I actually think its the subframe on my R33 that has a bit of a bend in it, from being jacked in the middle too. However, it could have been one of my many other cars I've had over the years! Or it could also be the from me jacking it up, and the fact the top of the front radiator support isn't there, so it can allow the front of the car to move and bend etc.
×
×
  • Create New...