Jump to content
SAU Community

Recommended Posts

>30K SPENT

PAINT TURNS AQUA FROM BLUE SCOOP IS HARLIQUIN !!! CANT SEE IN PICS!!!!!

ALL COMPLIED AND PLATED

WRX MOTOR AWD TURBO ENGINE LOTS WORK

list too big motor pushing 300hp !! SEE PICS!! 3g spent on motor .in the last month (receipts)

INTERNALS

ALL CUSTOM PIPING

BIG INTERCOOLER

NEW GAUGES

NEW BOV

NEW TURBO TIMER

NEW BOOST CONTROLL

FULL WIDEBODY

NEW ALPINE CD WMA MP3

ALL CUSTOM BLACK LEATHER INTERIOR

5 SPEED

18s CHROME

TURBO

FULL DYNO TUNED

TWIN SPORTS EXHAUST TO 2 CANNONS

wicked wrx grumble

PEARL PAINT BLUE TO AQUA

HARLIQUIN SCOOP

post-68974-1261311938_thumb.jpg

post-68974-1261311967_thumb.jpg

post-68974-1261312016_thumb.jpg

post-68974-1261312041_thumb.jpg

post-68974-1261312062_thumb.jpg

???? bargain.. DONT MISS OUT

2006 GT-B FRONT. 97 B4 LIBERTY BACK. 2000 WRX MOTOR. 100KMS SINCE REBUILD AT APC BRISBANE..

BUILT AND COMPLIED IN 2008

Edited by katurbo
Guest
This topic is now closed to further replies.


  • Latest Posts

    • Ah! I actually managed to snag a lightly used set.... that aren't so suitable for me right now. They don't work on a GTT without some cutting or creative heat moulding. I thought about reselling them myself cause I didn't want to murder them, but it looks like I'm probably going to attempt to murder them/melt them because I may as well. @GTSBoy @PranK can somebody close this thread?
    • Hey mate,  I have a set, one is slightly damaged but wont be noticable once installed.  Shoot me a message if your still after them 
    • I couldn't wait But, the black constant tension hose clamps were too thick and there wasn't enough clearance at the T/B and I couldn't get it to seat properly, so I had use a silver one there I also added some 3" silicone over the alloy bit that goes through to hole on the radiator support as it looked like it was sitting on the edge of the hole in the radiator support, I never noticed a rattle or anything, but there was a witness mark It is basicly done, and I can live with the silver hose clamp at the T/B, I will get a black clamp for the head vent though where it is attached to the bulkhead fitting  It never stops...LOL, only issue now with the shock tower brace is it slightly touches the under bonnet liner now, if I leave it it will either wear some paint off the brace where it touches, or damage the liner, so I removed the liner to see what I have to work with, with the liner removed I have about 20mm of clearance, but sadly the middle part of the underside of the bonnet is only dusted with paint and looks crap, so I cannot have that, but.... as I have a roll of Carbuilders premium under bonnet insulation in the garage laying around that is only 5.5mm thick (we were going to use it on the boys Patrol, but he crashed the front of it a few months and it was written off, hence why he now drives my old Honda Accord Euro), I'll use the OEM liner as a template and get the Carbuilders stuff fitted up to cover that dusted paint up
    • You have a knack for photography my friend. It makes the 86 look like a complete bucket. The 34 went with you to Europe and back. It's special. (we all feel the same about our 'shitboxes' that every bystander seems to absolutely love)
×
×
  • Create New...