Jump to content
SAU Community

Recommended Posts

1987 hr31 gts 4 door

was fixing this car up but have to let it go now, motor always ran fine tho its pushing the dipstick out sometimes. no noises from motor, doesnt chew oil, doesnt blow any smoke hot or cold.

engine:

transport depart. told me its a 94 model silvertop rb20det.

vg30 turbo

full 3" exhaust

999 fuel reg

walbro 255 fuel pump

supra fmic

turbosmart boost controller

adthree nissan motorsport front strut brace

i replaced the front sway bar link bushes with urethane bushes and the same for the castor rods, needs new shocks and a power steering hose replaced, ive just taken the belt off for now. drivers seat has small wear mark on right leg cushion, top of door cards lookin bit sad now too. rest of carpet and interior is in pretty good condition. rear passenger window motor just died all others work, all lights work, new ignition barrel, locks and keys. series 3 front end.

cant think of anything else.. car ran outa rego last week. welcome to do any sort of checks on motor or whatever

post-68039-1274698262_thumb.jpg

post-68039-1274698269_thumb.jpg

post-68039-1274698274_thumb.jpg

post-68039-1274698332_thumb.jpg

post-68039-1274698339_thumb.jpg

located in logan city, call daniel on 0423921892

$3500

post-68039-1274698312_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/321977-bris-hr31-gts-silvertop/
Share on other sites

gts or passage bro?

sounds like the motor has blow by which is usually the result of to much boost.

rb20 silvertop are cheap. fix it dont sell it.

these are rare to find cars.

its a gts mate, i would LOVE to keep her even had everything needed for 25 conversion, microtech, injectors had it all but some bad times have come along and sadly have to let it all go, very frigin sad :rofl2:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Was that with the cas upside or correct way up?
    • Did and sync timing with light 
    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
×
×
  • Create New...