Jump to content
SAU Community

Recommended Posts

Like last Friday/Thursday? Mass amounts of police pulling people over for speeding on Mitchell Freeway after City West before Leederville Traino.

Remember its 80ks until you pass Vincet Street exit. Saw alot of vans and tradies getting tickets.

Seems like they may be doing this on a regular basis so watch out!

Link to comment
https://www.sau.com.au/forums/topic/326264-bikercops-on-the-freeway/
Share on other sites

I got done for 95 in an 80 zone by the exact same thing.. except on the OTHER side of the city. Just after the swan river bridge, they were hiding around a corner just before it turns 100. Damn those sneaky popo :l

At the part of the freeway more people are already traveling closer to 100 than 80, I can't see the reason why it can't just be 100, but that's the reason the cops are there. Revenue, not safety.

yeah, I've seen them there a couple times... usually on a friday morning. about 5 bikes in a row, with one guy with a radar gun. He'll give a wave and point and they will be off, on after the other. I watched them for a bit, while waiting on the thomas st off ramp. It sounds like they have found a great way to make money, other then multinovas :miner:

Better watch my a** then. But so far I found almost everyone would be driving at least 10km/h over at the 80km/h freeway zones so I usually just follow the pack... eehh safety in numbers?

Speaking of which I just went past one of those dual function cameras at Leech/Albany highway, those things looked way different from the regular single red light cameras also i have added an additional warning POI in my GPS :P

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • UPDATE: Yes the GSP Axles are compatible. I installed it on my R34 today and they are working a treat! Turns out that the S13, S14, S15, and 200 SX all used the same axles as the HR34, and ER34 NA models. Which is 2 bolt x 3 pairs.  
    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
×
×
  • Create New...